XALD321
현행 제품Schneider Harmony XALD 3-Button Station (green/red/green, XALD321)
Schneider XALD 3-button station — start, stop, and e-stop.
일반적인 용도
Complete motor control station: green start, red stop, and red mushroom e-stop in one IP66 enclosure. The standard for remote motor control on conveyors, pumps, and fans. Meets OSHA requirements for accessible e-stop within reach of the operator.
사양 목록
|
Certifications
Third-party safety certifications. UL = required for US NEC installations. CE = EU compliance. CSA = Canadian standards.
|
UL, CSA, CE
|
|
Color
Button/actuator color. Green = start/go, Red = stop/emergency, Yellow = caution, Blue = reset (per IEC 60204-1).
|
Green + Red + Green (three flush pushbuttons)
|
|
Contact Configuration
Normally Open — circuit is off until you press. Standard for start/go/enable functions.
|
~2NO + 1NC (verify from full catalog number)
|
|
Full catalog
|
XALD321H29H7
|
|
IP Rating
IP66: Dust-tight and withstands powerful water jets from any direction. Standard for outdoor and washdown applications.
|
IP66
|
|
Mounting Type
How the button attaches to the panel. Panel mount is standard — installs through a cutout from the front.
|
Surface mount (enclosed)
|
|
Operators
|
Green flush / red flush / green flush Ø22 (XB5) — NO e-stop mushroom
|
|
Pn note
|
Corrected: XALD321 = green/red/green 3-button station (se.com datasheet), NOT Start/Stop/E-Stop. The 3rd button is green flush, not an e-stop mushroom.
|
|
Pn status
|
mislabel-corrected
|
설치 빠른 참조
Panel cutout: 22mm. Insert from the front of the panel, secure with mounting nut from behind (tighten to 2-3 Nm).
Contact block: Snap or screw the contact block onto the rear of the button body. Ensure the contact block orientation matches the wiring diagram — NO terminals are usually marked.
Wiring: Use 0.5-2.5mm² stranded wire with ferrules. Tighten screw terminals to 0.8 Nm. Test the button function before energizing the circuit.
외형 치수
배선도
문제 해결
Button doesn't respond when pressed
Check the contact block first — it's the most common failure point. Test continuity across the NO or NC terminals with a multimeter. If no click is felt, the return spring in the head may be broken.
Works intermittently
Contact block contacts are pitted or burned. Replace the contact block — don't try to file the contacts. Check if the rated cycle count has been exceeded.
Button feels mushy or doesn't click
The spring return mechanism in the button head is worn. Replace the head. The contact block can usually be reused if it tests OK.
구매처
가격 범위
$5.37 — $45.32
2개 대리점
주요 사양
- Certifications
- UL, CSA, CE
- Color
- Green + Red + Green (three flush pushbuttons)
- Contact Configuration
- ~2NO + 1NC (verify from full catalog number)
- Full catalog
- XALD321H29H7
- IP Rating
- IP66
사용자 후기
“Complete motor control station: green start, red stop, and red mushroom e-stop in one IP66 enclosure. The standard for remote motor control on conveyors, pumps, and fans. Meets OSHA requirements for a”
