ZB4BK1333
نشطSchneider ZB4BK1333 Green Illuminated 2-Position Selector Switch Head (Harmony XB4, head-only)
Schneider XB4 complete illuminated 2-position selector.
التطبيقات الشائعة
Complete illuminated selector — green LED lit in the active position. Confirms the selected mode visually. Pre-assembled with contacts.
المواصفات
|
Actuator Function
Momentary = springs back when released. Maintained/latching = stays pressed until pressed again.
|
Maintained
|
|
Certifications
Third-party safety certifications. UL = required for US NEC installations. CE = EU compliance. CSA = Canadian standards.
|
UL, CSA, CE
|
|
Color
Button/actuator color. Green = start/go, Red = stop/emergency, Yellow = caution, Blue = reset (per IEC 60204-1).
|
Green
|
|
Contact Configuration
Normally Open — circuit is off until you press. Standard for start/go/enable functions.
|
None integral (head-only; add ZB4 contact block)
|
|
Cutout Diameter
The hole size you drill in your panel to mount this button. 22mm is the most common industrial standard worldwide.
|
22mm
|
|
Device type
|
ZB4-BK illuminated 2-position selector switch HEAD (green); LED module + contact separate; complete = XB4-BK1333
|
|
Illumination
Whether the button has a built-in light. Illuminated buttons show status (lit = active).
|
Illuminated
|
|
IP Rating
IP66: Dust-tight and withstands powerful water jets from any direction. Standard for outdoor and washdown applications.
|
IP66
|
|
LED Voltage
The voltage required for the built-in LED. Must match your control circuit voltage (typically 24V DC or 230V AC).
|
Not inherent to head — set by separate ZBV LED module (24/120/230V)
|
|
Material
The bezel/body material. Metal bezels are more durable in harsh environments. Plastic is lighter and cheaper.
|
Metal
|
|
Pn note
|
Corrected: ZB4BK1333 = green illuminated 2-position selector HEAD (se.com). Not complete; voltage-independent (24V not inherent; LED via separate ZBV module). -COMP suffix bogus (scrape artifact) -> re-keyed ZB4BK1333.
|
|
Pn status
|
head-only + -COMP-suffix-stripped
|
مرجع سريع للتركيب
Panel cutout: 22mm. Align the selector positions with the desired panel markings before tightening.
Contact blocks: Attach one contact block per position. Wire each to a separate PLC input for position feedback. A 2-position switch needs 1-2 blocks; 3-position needs 2-3.
الأبعاد
مخطط التوصيل
استكشاف الأعطال وإصلاحها
Not responding to input
Check wiring continuity with a multimeter. Verify the contact block is properly seated. Inspect terminals for loose connections.
أين تشتري
نطاق السعر
$113.59 — $211.84
عبر 2 موزع
مواصفات سريعة
- Actuator Function
- Maintained
- Certifications
- UL, CSA, CE
- Color
- Green
- Contact Configuration
- None integral (head-only; add ZB4 contact block)
- Cutout Diameter
- 22mm
ما يقوله المستخدمون
“Complete illuminated selector — green LED lit in the active position. Confirms the selected mode visually. Pre-assembled with contacts.”