IS15ABFP4CF
Hoạt độngSmartSwitch OLED Programmable Button
NKK SmartSwitch — push button with built-in OLED display.
Ứng Dụng Phổ Biến
A push button with a tiny OLED screen built into the cap. The display changes dynamically to show the current function — the same physical button can be Start, Stop, Mode Select, or anything else depending on the software state. Used in broadcast mixing consoles, audio equipment, test instrumentation, and military command systems. The button literally tells you what it does.
Thông số kỹ thuật
|
Actuator Function
Momentary = springs back when released. Maintained/latching = stays pressed until pressed again.
|
Momentary
|
|
Certifications
Third-party safety certifications. UL = required for US NEC installations. CE = EU compliance. CSA = Canadian standards.
|
UL, CE
|
|
Cutout Diameter
The hole size you drill in your panel to mount this button. 22mm is the most common industrial standard worldwide.
|
15mm
|
|
Display
|
36x24 pixel OLED
|
|
Interface
|
SPI
|
|
IP Rating
Ingress Protection rating — first digit is dust (0-6), second is water (0-9). Higher is better.
|
IP40
|
Hướng Dẫn Cài Đặt Nhanh
Panel cutout: 15mm. Insert from the front of the panel, secure with mounting nut from behind (tighten to 2-3 Nm).
Contact block: Snap or screw the contact block onto the rear of the button body. Ensure the contact block orientation matches the wiring diagram — NO terminals are usually marked.
Wiring: Use 0.5-2.5mm² stranded wire with ferrules. Tighten screw terminals to 0.8 Nm. Test the button function before energizing the circuit.
Kích thước
Khắc phục sự cố
Button doesn't respond when pressed
Check the contact block first — it's the most common failure point. Test continuity across the NO or NC terminals with a multimeter. If no click is felt, the return spring in the head may be broken.
Works intermittently
Contact block contacts are pitted or burned. Replace the contact block — don't try to file the contacts. Check if the rated cycle count has been exceeded.
Button feels mushy or doesn't click
The spring return mechanism in the button head is worn. Replace the head. The contact block can usually be reused if it tests OK.
Nơi Mua Hàng
Dải giá
$71.54 — $87.19
từ 2 nhà phân phối
Thông số kỹ thuật nhanh
- Actuator Function
- Momentary
- Certifications
- UL, CE
- Cutout Diameter
- 15mm
- Display
- 36x24 pixel OLED
- Interface
- SPI
Những Đánh Giá Từ Khách Hàng
“A push button with a tiny OLED screen built into the cap. The display changes dynamically to show the current function — the same physical button can be Start, Stop, Mode Select, or anything else depe”
