800T-T2MB
Hoạt động800T 2-Button Pendant Station
Allen-Bradley 800T 2-button pendant — up/down hoist control.
Ứng Dụng Phổ Biến
Simple 2-button pendant for single-axis hoist control. Up/Down in a NEMA 4 sealed housing. The American equivalent of the European crane pendant — found on US-built overhead hoists and monorails. Uses standard 800T heavy-duty buttons inside.
Thông số kỹ thuật
|
Actuator Function
Momentary = springs back when released. Maintained/latching = stays pressed until pressed again.
|
Momentary
|
|
Certifications
Third-party safety certifications. UL = required for US NEC installations. CE = EU compliance. CSA = Canadian standards.
|
UL, CSA
|
|
Contact Configuration
Normally Open — circuit is off until you press. Standard for start/go/enable functions.
|
2x 1NO
|
|
IP Rating
Ingress Protection rating — first digit is dust (0-6), second is water (0-9). Higher is better.
|
NEMA 4
|
|
Material
The bezel/body material. Metal bezels are more durable in harsh environments. Plastic is lighter and cheaper.
|
Die-cast aluminum
|
Hướng Dẫn Cài Đặt Nhanh
Panel cutout: 22mm. Insert from the front of the panel, secure with mounting nut from behind (tighten to 2-3 Nm).
Contact block: Snap or screw the contact block onto the rear of the button body. Ensure the contact block orientation matches the wiring diagram — NO terminals are usually marked.
Wiring: Use 0.5-2.5mm² stranded wire with ferrules. Tighten screw terminals to 0.8 Nm. Test the button function before energizing the circuit.
Kích thước
Sơ đồ đấu dây
Khắc phục sự cố
Button doesn't respond when pressed
Check the contact block first — it's the most common failure point. Test continuity across the NO or NC terminals with a multimeter. If no click is felt, the return spring in the head may be broken.
Works intermittently
Contact block contacts are pitted or burned. Replace the contact block — don't try to file the contacts. Check if the rated cycle count has been exceeded.
Button feels mushy or doesn't click
The spring return mechanism in the button head is worn. Replace the head. The contact block can usually be reused if it tests OK.
Nơi Mua Hàng
Dải giá
$5.39 — $78.69
từ 2 nhà phân phối
Thông số kỹ thuật nhanh
- Actuator Function
- Momentary
- Certifications
- UL, CSA
- Contact Configuration
- 2x 1NO
- IP Rating
- NEMA 4
- Material
- Die-cast aluminum
Những Đánh Giá Từ Khách Hàng
“Simple 2-button pendant for single-axis hoist control. Up/Down in a NEMA 4 sealed housing. The American equivalent of the European crane pendant — found on US-built overhead hoists and monorails. Uses”