AR22-S2-01
AktywnyAR22 22mm 2-Position Selector 1NO
Fuji AR22 2-position selector.
Typowe Zastosowania
Manual/Auto selector for Fuji panels.
Specyfikacje
|
Actuator Function
Momentary = springs back when released. Maintained/latching = stays pressed until pressed again.
|
Maintained
|
|
Certifications
Third-party safety certifications. UL = required for US NEC installations. CE = EU compliance. CSA = Canadian standards.
|
JIS, UL, CE
|
|
Contact Configuration
Normally Open — circuit is off until you press. Standard for start/go/enable functions.
|
1NO
|
|
Cutout Diameter
The hole size you drill in your panel to mount this button. 22mm is the most common industrial standard worldwide.
|
22mm
|
Skrócona Instrukcja Montażu
Panel cutout: 22mm. Align the selector positions with the desired panel markings before tightening.
Contact blocks: Attach one contact block per position. Wire each to a separate PLC input for position feedback. A 2-position switch needs 1-2 blocks; 3-position needs 2-3.
Wymiary
Schemat Połączeń
Rozwiązywanie Problemów
Not responding to input
Check wiring continuity with a multimeter. Verify the contact block is properly seated. Inspect terminals for loose connections.
Gdzie Kupić
Przedział cenowy
$5.34 — $52.92
u 2 dystrybutorów
Skrócone Specyfikacje
- Actuator Function
- Maintained
- Certifications
- JIS, UL, CE
- Contact Configuration
- 1NO
- Cutout Diameter
- 22mm
Co Mówią Użytkownicy
“Manual/Auto selector for Fuji panels.”