ZBE-1016P
現行品ZBE Spring-Return Contact 1NO+1NC Stacked
Schneider ZBE dual contact element — 1NO+1NC in one block.
主な用途
Stacked dual contact element. 1NO for start signal + 1NC for PLC feedback, from a single stackable block. Saves space vs two separate blocks. Snaps onto any Harmony XB4/XB5 mounting base.
互換性
Fits all Schneider Harmony XB4, XB5, and legacy Telemecanique XB2 mounting bases. Stacks with other ZBE elements for up to 4 contacts per button.
仕様一覧
|
Certifications
Third-party safety certifications. UL = required for US NEC installations. CE = EU compliance. CSA = Canadian standards.
|
UL, CSA, CE
|
|
Contact Configuration
1NO + 1NC: One circuit closes and one opens when pressed. Common for start buttons that also signal 'running' state.
|
1NO+1NC
|
|
Mechanical Life
How many press cycles before mechanical failure. Higher is better — 10M cycles at 100 presses/day = 274 years.
|
10,000,000 cycles
|
|
Terminal Type
How you connect wires. Screw clamp is most common in industrial. Spring cage is faster but requires proper ferrules.
|
Screw clamp
|
取付クイックリファレンス
Mounting: Snap onto the rear of any compatible button body in the same series. The latch clicks audibly when properly seated. Some models require a mounting adapter.
Wiring: Terminals are marked NO (11/12) or NC (21/22). Use 0.5-2.5mm² wire with ferrules. Tighten to 0.8 Nm. Verify with a multimeter before energizing.
外形寸法
配線図
トラブルシューティング
Intermittent switching
Silver contacts are pitted from arcing. Replace the contact block — they are consumable parts. If arcing is severe, check that the switched load doesn't exceed the contact rating (typically 6A at 120VAC).
Contact block won't snap onto button body
Verify the contact block series matches the button head series (e.g., Schneider ZB4 blocks fit ZB4 heads only, not ZB5). Check for debris or damage on the mounting tabs.
主要仕様
- Certifications
- UL, CSA, CE
- Contact Configuration
- 1NO+1NC
- Mechanical Life
- 10,000,000 cycles
- Terminal Type
- Screw clamp
ユーザーの声
“Stacked dual contact element. 1NO for start signal + 1NC for PLC feedback, from a single stackable block. Saves space vs two separate blocks. Snaps onto any Harmony XB4/XB5 mounting base.”
