M22-K01
AktivM22 1NC Contact Block
Eaton M22 series 1NC contact block.
Typische Anwendungen
1NC contact block for stop and safety circuits. The NC contact breaks the circuit when pressed — fail-safe design. Wire in series with motor contactor coil. Keep spares on hand — contact blocks are the most common failure point.
Kompatibilität
Same compatibility as M22-K10. NC version. Fits all M22 operators.
Reparatur & Wartung
NC contacts are safety-critical — replace every 5 years as preventive maintenance on e-stop circuits regardless of test results.
Spezifikationen
|
Certifications
Third-party safety certifications. UL = required for US NEC installations. CE = EU compliance. CSA = Canadian standards.
|
UL, CSA, CE
|
|
Contact Configuration
Normally Closed — circuit is on until you press. Standard for stop/emergency functions. Wire in series with safety circuits.
|
1NC
|
|
Mechanical Life
How many press cycles before mechanical failure. Higher is better — 10M cycles at 100 presses/day = 274 years.
|
10,000,000 cycles
|
|
Series
The manufacturer's product family. Products in the same series share mounting systems and accessories.
|
M22
|
|
Terminal Type
How you connect wires. Screw clamp is most common in industrial. Spring cage is faster but requires proper ferrules.
|
Screw clamp
|
Installationskurzanleitung
Mounting: Snap onto the rear of any compatible button body in the same series. The latch clicks audibly when properly seated. Some models require a mounting adapter.
Wiring: Terminals are marked NO (11/12) or NC (21/22). Use 0.5-2.5mm² wire with ferrules. Tighten to 0.8 Nm. Verify with a multimeter before energizing.
Abmessungen
Schaltplan
Fehlerbehebung
Intermittent switching
Silver contacts are pitted from arcing. Replace the contact block — they are consumable parts. If arcing is severe, check that the switched load doesn't exceed the contact rating (typically 6A at 120VAC).
Contact block won't snap onto button body
Verify the contact block series matches the button head series (e.g., Schneider ZB4 blocks fit ZB4 heads only, not ZB5). Check for debris or damage on the mounting tabs.
Bezugsquellen
Preisbereich
$12.52 — $74.4
bei 3 Händlern
Kurzspezifikationen
- Certifications
- UL, CSA, CE
- Contact Configuration
- 1NC
- Mechanical Life
- 10,000,000 cycles
- Series
- M22
- Terminal Type
- Screw clamp
Das sagen Anwender
“1NC contact block for stop and safety circuits. The NC contact breaks the circuit when pressed — fail-safe design. Wire in series with motor contactor coil. Keep spares on hand — contact blocks are th”