800F-1XA10-A1G
Aktiv800F 1-Button Green Start Station Enclosed
Allen-Bradley 800F enclosed start station.
Typische Anwendungen
Complete AB start station in NEMA 4 enclosure. Pre-assembled 800F green button with 1NO contact. For remote start points on US industrial equipment.
Spezifikationen
|
Certifications
Third-party safety certifications. UL = required for US NEC installations. CE = EU compliance. CSA = Canadian standards.
|
UL, CSA
|
|
Color
Button/actuator color. Green = start/go, Red = stop/emergency, Yellow = caution, Blue = reset (per IEC 60204-1).
|
Green
|
|
Contact Configuration
Normally Open — circuit is off until you press. Standard for start/go/enable functions.
|
1NO
|
|
IP Rating
Ingress Protection rating — first digit is dust (0-6), second is water (0-9). Higher is better.
|
NEMA 4
|
|
Mounting Type
How the button attaches to the panel. Panel mount is standard — installs through a cutout from the front.
|
Surface mount (enclosed)
|
|
Pn note
|
800F-1XA10-A1G does not resolve to a real product (only generic 800F literature + the 800F-X10 contact block). 800F is a 22mm OPERATOR/CONTACT-BLOCK line, NOT enclosed control stations (those are AB 800T/800H). Description is the fabricated boilerplate template shared with #430/#432 (1-Button Green Start Station Enclosed / green / 1NO). Joins the 800F fabricated cluster (#282/#283/#300/#301/#319/#332/#354). Flag/skip.
|
|
Pn status
|
fabricated / unverifiable
|
Installationskurzanleitung
Panel cutout: 22mm. Insert from the front of the panel, secure with mounting nut from behind (tighten to 2-3 Nm).
Contact block: Snap or screw the contact block onto the rear of the button body. Ensure the contact block orientation matches the wiring diagram — NO terminals are usually marked.
Wiring: Use 0.5-2.5mm² stranded wire with ferrules. Tighten screw terminals to 0.8 Nm. Test the button function before energizing the circuit.
Abmessungen
Schaltplan
Fehlerbehebung
Button doesn't respond when pressed
Check the contact block first — it's the most common failure point. Test continuity across the NO or NC terminals with a multimeter. If no click is felt, the return spring in the head may be broken.
Works intermittently
Contact block contacts are pitted or burned. Replace the contact block — don't try to file the contacts. Check if the rated cycle count has been exceeded.
Button feels mushy or doesn't click
The spring return mechanism in the button head is worn. Replace the head. The contact block can usually be reused if it tests OK.
Bezugsquellen
Preisbereich
$5.33 — $84.97
bei 2 Händlern
Kurzspezifikationen
- Certifications
- UL, CSA
- Color
- Green
- Contact Configuration
- 1NO
- IP Rating
- NEMA 4
- Mounting Type
- Surface mount (enclosed)
Das sagen Anwender
“Complete AB start station in NEMA 4 enclosure. Pre-assembled 800F green button with 1NO contact. For remote start points on US industrial equipment.”