A7PB-206-1
AktivníA7PB DIN Rail Mount Push Button
Omron A7PB DIN rail mounted push button — mounts directly on DIN rail.
Běžné aplikace
Push button that clips directly onto standard 35mm DIN rail inside a panel enclosure. No panel cutout needed. Used for test/reset functions accessible only when the panel door is open. Perfect for commissioning, testing, and maintenance access.
Specifikace
|
Certifications
Third-party safety certifications. UL = required for US NEC installations. CE = EU compliance. CSA = Canadian standards.
|
UL, CE
|
|
Contact Configuration
The electrical switching arrangement.
|
SPDT
|
|
Mounting Type
How the button attaches to the panel. Panel mount is standard — installs through a cutout from the front.
|
DIN rail (35mm)
|
Stručný průvodce instalací
Panel cutout: 22mm. Insert from the front of the panel, secure with mounting nut from behind (tighten to 2-3 Nm).
Contact block: Snap or screw the contact block onto the rear of the button body. Ensure the contact block orientation matches the wiring diagram — NO terminals are usually marked.
Wiring: Use 0.5-2.5mm² stranded wire with ferrules. Tighten screw terminals to 0.8 Nm. Test the button function before energizing the circuit.
Rozměry
Schéma zapojení
Řešení problémů
Button doesn't respond when pressed
Check the contact block first — it's the most common failure point. Test continuity across the NO or NC terminals with a multimeter. If no click is felt, the return spring in the head may be broken.
Works intermittently
Contact block contacts are pitted or burned. Replace the contact block — don't try to file the contacts. Check if the rated cycle count has been exceeded.
Button feels mushy or doesn't click
The spring return mechanism in the button head is worn. Replace the head. The contact block can usually be reused if it tests OK.
Kde koupit
Cenové rozpětí
$114.95 — $133.61
u 2 distributorů
Stručné specifikace
- Certifications
- UL, CE
- Contact Configuration
- SPDT
- Mounting Type
- DIN rail (35mm)
Co říkají uživatelé
“Push button that clips directly onto standard 35mm DIN rail inside a panel enclosure. No panel cutout needed. Used for test/reset functions accessible only when the panel door is open. Perfect for com”