1SFA619100R2072
在产ABB CP1-20G-11 Compact Green Pushbutton 1NO+1NC
ABB CP compact 2-button start/stop control station.
常见应用
ABB compact enclosed start/stop. Slimmer profile than competitors. Same 22mm mounting internally.
规格参数
|
Certifications
Third-party safety certifications. UL = required for US NEC installations. CE = EU compliance. CSA = Canadian standards.
|
UL, CSA, CE
|
|
Color
Button/actuator color. Green = start/go, Red = stop/emergency, Yellow = caution, Blue = reset (per IEC 60204-1).
|
Green (single pushbutton)
|
|
Contact Configuration
1NO + 1NC: One circuit closes and one opens when pressed. Common for start buttons that also signal 'running' state.
|
1NO + 1NC
|
|
Device type
|
Single CP1 compact pushbutton (NOT a 2-button station)
|
|
IP Rating
IP66: Dust-tight and withstands powerful water jets from any direction. Standard for outdoor and washdown applications.
|
IP66
|
|
Mounting Type
How the button attaches to the panel. Panel mount is standard — installs through a cutout from the front.
|
22mm panel cutout
|
|
Pn note
|
1SFA619100R2072 = ABB CP1-20G-11 single GREEN compact pushbutton, 1NO+1NC (quadindustry/ABB). Was mislabeled as a 2-button green/red enclosed start/stop station. 1SFA619100Rxxxx = individual CP1 pushbuttons, not stations.
|
|
Pn status
|
mislabel-corrected
|
|
Type designation
|
CP1-20G-11
|
安装快速参考
Panel cutout: 22mm. Insert from the front of the panel, secure with mounting nut from behind (tighten to 2-3 Nm).
Contact block: Snap or screw the contact block onto the rear of the button body. Ensure the contact block orientation matches the wiring diagram — NO terminals are usually marked.
Wiring: Use 0.5-2.5mm² stranded wire with ferrules. Tighten screw terminals to 0.8 Nm. Test the button function before energizing the circuit.
尺寸
接线图
故障排除
Button doesn't respond when pressed
Check the contact block first — it's the most common failure point. Test continuity across the NO or NC terminals with a multimeter. If no click is felt, the return spring in the head may be broken.
Works intermittently
Contact block contacts are pitted or burned. Replace the contact block — don't try to file the contacts. Check if the rated cycle count has been exceeded.
Button feels mushy or doesn't click
The spring return mechanism in the button head is worn. Replace the head. The contact block can usually be reused if it tests OK.
快速规格
- Certifications
- UL, CSA, CE
- Color
- Green (single pushbutton)
- Contact Configuration
- 1NO + 1NC
- Device type
- Single CP1 compact pushbutton (NOT a 2-button station)
- IP Rating
- IP66
用户评价
“ABB compact enclosed start/stop. Slimmer profile than competitors. Same 22mm mounting internally.”