IDEC · HW Dòng sản phẩm

HW-C10

Hoạt động
UL CE

HW 1NO Contact Block

IDEC HW Dòng sản phẩm Introduced circa 2005

IDEC HW series 1NO contact block.

Ứng Dụng Phổ Biến

IDEC native contact block for the HW series. Snaps onto any HW button head. Budget-friendly replacement part. 30-40% cheaper than Schneider/Eaton equivalents.

Thông số kỹ thuật

Certifications
UL, CE
Contact Configuration
1NO
Mechanical Life
10,000,000 cycles
Terminal Type
Screw clamp

Hướng Dẫn Cài Đặt Nhanh

Mounting: Snap onto the rear of any compatible button body in the same series. The latch clicks audibly when properly seated. Some models require a mounting adapter.

Wiring: Terminals are marked NO (11/12) or NC (21/22). Use 0.5-2.5mm² wire with ferrules. Tighten to 0.8 Nm. Verify with a multimeter before energizing.

Kích thước

Sơ đồ đấu dây

L T 11 12 NO (open) press ↓

Khắc phục sự cố

Intermittent switching

Silver contacts are pitted from arcing. Replace the contact block — they are consumable parts. If arcing is severe, check that the switched load doesn't exceed the contact rating (typically 6A at 120VAC).

Contact block won't snap onto button body

Verify the contact block series matches the button head series (e.g., Schneider ZB4 blocks fit ZB4 heads only, not ZB5). Check for debris or damage on the mounting tabs.

Nơi Mua Hàng

Dải giá

$4.62 — $71.69

từ 2 nhà phân phối

Thông số kỹ thuật nhanh

Certifications
UL, CE
Contact Configuration
1NO
Mechanical Life
10,000,000 cycles
Terminal Type
Screw clamp

Những Đánh Giá Từ Khách Hàng

+

“IDEC native contact block for the HW series. Snaps onto any HW button head. Budget-friendly replacement part. 30-40% cheaper than Schneider/Eaton equivalents.”

Reddit r/PLC 20 lượt bình chọn Xem ren

Thêm sản phẩm từ IDEC