IDEC · HW Serie

HW-C10

Activ
UL CE

HW 1NO Contact Block

IDEC HW Serie Introduced circa 2005

IDEC HW series 1NO contact block.

Aplicații frecvente

IDEC native contact block for the HW series. Snaps onto any HW button head. Budget-friendly replacement part. 30-40% cheaper than Schneider/Eaton equivalents.

Specificații

Certifications
UL, CE
Contact Configuration
1NO
Mechanical Life
10,000,000 cycles
Terminal Type
Screw clamp

Referință rapidă de instalare

Mounting: Snap onto the rear of any compatible button body in the same series. The latch clicks audibly when properly seated. Some models require a mounting adapter.

Wiring: Terminals are marked NO (11/12) or NC (21/22). Use 0.5-2.5mm² wire with ferrules. Tighten to 0.8 Nm. Verify with a multimeter before energizing.

Dimensiuni

Schemă de cablare

L T 11 12 NO (open) press ↓

Depanare

Intermittent switching

Silver contacts are pitted from arcing. Replace the contact block — they are consumable parts. If arcing is severe, check that the switched load doesn't exceed the contact rating (typically 6A at 120VAC).

Contact block won't snap onto button body

Verify the contact block series matches the button head series (e.g., Schneider ZB4 blocks fit ZB4 heads only, not ZB5). Check for debris or damage on the mounting tabs.

De unde cumpărați

Interval de preț

$4.62 — $71.69

la 2 distribuitori

Specificații rapide

Certifications
UL, CE
Contact Configuration
1NO
Mechanical Life
10,000,000 cycles
Terminal Type
Screw clamp

Ce spun utilizatorii

+

“IDEC native contact block for the HW series. Snaps onto any HW button head. Budget-friendly replacement part. 30-40% cheaper than Schneider/Eaton equivalents.”

Reddit r/PLC 20 voturi pozitive Vedeți discuția →