AR22F0R-10G
Hoạt độngAR22 22mm Green Flush Push Button 1NO
Fuji Electric AR22 green push button — Japanese industrial standard.
Ứng Dụng Phổ Biến
The default push button in Japanese factories using Fuji drives and PLCs. AR22 is Fujis 22mm modular range — equivalent to Schneider XB4 and Eaton M22. Common on machine tools, food processing, and semiconductor equipment built in Japan. If the panel has a Fuji FRENIC drive, the buttons are likely AR22.
Thông số kỹ thuật
|
Actuator Function
Momentary = springs back when released. Maintained/latching = stays pressed until pressed again.
|
Momentary
|
|
Actuator Type
The button head style. Flush sits level with the bezel (prevents accidental presses). Extended protrudes for easy access.
|
Flush
|
|
Certifications
Third-party safety certifications. UL = required for US NEC installations. CE = EU compliance. CSA = Canadian standards.
|
JIS, UL, CE
|
|
Color
Button/actuator color. Green = start/go, Red = stop/emergency, Yellow = caution, Blue = reset (per IEC 60204-1).
|
Green
|
|
Contact Configuration
Normally Open — circuit is off until you press. Standard for start/go/enable functions.
|
1NO
|
|
Cutout Diameter
The hole size you drill in your panel to mount this button. 22mm is the most common industrial standard worldwide.
|
22mm
|
|
IP Rating
IP65: Dust-tight and protected against low-pressure water jets. Suitable for indoor industrial and light washdown.
|
IP65
|
Hướng Dẫn Cài Đặt Nhanh
Panel cutout: 22mm. Insert from the front of the panel, secure with mounting nut from behind (tighten to 2-3 Nm).
Contact block: Snap or screw the contact block onto the rear of the button body. Ensure the contact block orientation matches the wiring diagram — NO terminals are usually marked.
Wiring: Use 0.5-2.5mm² stranded wire with ferrules. Tighten screw terminals to 0.8 Nm. Test the button function before energizing the circuit.
Kích thước
Sơ đồ đấu dây
Khắc phục sự cố
Button doesn't respond when pressed
Check the contact block first — it's the most common failure point. Test continuity across the NO or NC terminals with a multimeter. If no click is felt, the return spring in the head may be broken.
Works intermittently
Contact block contacts are pitted or burned. Replace the contact block — don't try to file the contacts. Check if the rated cycle count has been exceeded.
Button feels mushy or doesn't click
The spring return mechanism in the button head is worn. Replace the head. The contact block can usually be reused if it tests OK.
Nơi Mua Hàng
Dải giá
$0.17 — $132.36
từ 2 nhà phân phối
Thông số kỹ thuật nhanh
- Actuator Function
- Momentary
- Actuator Type
- Flush
- Certifications
- JIS, UL, CE
- Color
- Green
- Contact Configuration
- 1NO
Những Đánh Giá Từ Khách Hàng
“The default push button in Japanese factories using Fuji drives and PLCs. AR22 is Fujis 22mm modular range — equivalent to Schneider XB4 and Eaton M22. Common on machine tools, food processing, and se”