M22-DP-Y
Hoạt động22mm Yellow Mushroom Palm Button
Eaton M22 40mm yellow mushroom button for two-hand control.
Ứng Dụng Phổ Biến
Yellow palm button for two-hand safety systems on presses and shears. Both buttons must be pressed simultaneously within 0.5s per EN 574. Prevents operator from reaching into the press opening. The yellow color means caution/intervention.
Thông số kỹ thuật
|
Actuator Function
Momentary = springs back when released. Maintained/latching = stays pressed until pressed again.
|
Momentary
|
|
Actuator Type
The button head style. Flush sits level with the bezel (prevents accidental presses). Extended protrudes for easy access.
|
Mushroom 40mm
|
|
Certifications
Third-party safety certifications. UL = required for US NEC installations. CE = EU compliance. CSA = Canadian standards.
|
UL, CSA, CE
|
|
Color
Button/actuator color. Green = start/go, Red = stop/emergency, Yellow = caution, Blue = reset (per IEC 60204-1).
|
Yellow
|
|
Cutout Diameter
The hole size you drill in your panel to mount this button. 22mm is the most common industrial standard worldwide.
|
22.5mm
|
|
IP Rating
IP67: Dust-tight and survives temporary water submersion (1m for 30 min). Handles oil splashes, steam cleaning, and rain.
|
IP67 (front)
|
|
Series
The manufacturer's product family. Products in the same series share mounting systems and accessories.
|
M22
|
Hướng Dẫn Cài Đặt Nhanh
Panel cutout: 22.5mm. Insert from the front of the panel, secure with mounting nut from behind (tighten to 2-3 Nm).
Contact block: Snap or screw the contact block onto the rear of the button body. Ensure the contact block orientation matches the wiring diagram — NO terminals are usually marked.
Wiring: Use 0.5-2.5mm² stranded wire with ferrules. Tighten screw terminals to 0.8 Nm. Test the button function before energizing the circuit.
Kích thước
Khắc phục sự cố
Button doesn't respond when pressed
Check the contact block first — it's the most common failure point. Test continuity across the NO or NC terminals with a multimeter. If no click is felt, the return spring in the head may be broken.
Works intermittently
Contact block contacts are pitted or burned. Replace the contact block — don't try to file the contacts. Check if the rated cycle count has been exceeded.
Button feels mushy or doesn't click
The spring return mechanism in the button head is worn. Replace the head. The contact block can usually be reused if it tests OK.
Nơi Mua Hàng
Dải giá
$12.87 — $84.7
từ 3 nhà phân phối
Thông số kỹ thuật nhanh
- Actuator Function
- Momentary
- Actuator Type
- Mushroom 40mm
- Certifications
- UL, CSA, CE
- Color
- Yellow
- Cutout Diameter
- 22.5mm
Những Đánh Giá Từ Khách Hàng
“Yellow palm button for two-hand safety systems on presses and shears. Both buttons must be pressed simultaneously within 0.5s per EN 574. Prevents operator from reaching into the press opening. The ye”