Siemens · SIRIUS ACT 시리즈

3SU1400-1AA10-1BA0

현행 제품
UL CSA CE

SIRIUS ACT 1NO Contact Block

부품 번호: 3SU1 - 10 - 1BA0
Siemens SIRIUS ACT 시리즈 Introduced circa 2013

Siemens SIRIUS ACT 1NO contact block — snap-on for all 3SU1 operators.

일반적인 용도

Native Siemens contact block for the SIRIUS ACT range. Snap-on mounting compatible with all 3SU1 metal and plastic front ring operators. TIA Portal configurable when used with AS-Interface module. Silver alloy contacts rated for 6A/240V.

사양 목록

Certifications
UL, CSA, CE
Contact Configuration
1NO
Mechanical Life
10,000,000 cycles
Terminal Type
Screw clamp

설치 빠른 참조

Mounting: Snap onto the rear of any compatible button body in the same series. The latch clicks audibly when properly seated. Some models require a mounting adapter.

Wiring: Terminals are marked NO (11/12) or NC (21/22). Use 0.5-2.5mm² wire with ferrules. Tighten to 0.8 Nm. Verify with a multimeter before energizing.

외형 치수

배선도

L T 11 12 NO (open) press ↓

문제 해결

Intermittent switching

Silver contacts are pitted from arcing. Replace the contact block — they are consumable parts. If arcing is severe, check that the switched load doesn't exceed the contact rating (typically 6A at 120VAC).

Contact block won't snap onto button body

Verify the contact block series matches the button head series (e.g., Schneider ZB4 blocks fit ZB4 heads only, not ZB5). Check for debris or damage on the mounting tabs.

주요 사양

Certifications
UL, CSA, CE
Contact Configuration
1NO
Mechanical Life
10,000,000 cycles
Terminal Type
Screw clamp

사용자 후기

+

“Native Siemens contact block for the SIRIUS ACT range. Snap-on mounting compatible with all 3SU1 metal and plastic front ring operators. TIA Portal configurable when used with AS-Interface module. Sil”

Reddit r/PLC 17 추천 스레드 보기 →