M22-I2-M1-M4
현행 제품M22 2-Button Start/Stop Station Enclosed
Eaton M22 2-button start/stop control station.
일반적인 용도
Eaton equivalent of the Schneider XALD211. Green start + red stop in IP67 enclosure. Surface-mount for remote motor control. Same M22 quality in a pre-built package.
사양 목록
|
Certifications
Third-party safety certifications. UL = required for US NEC installations. CE = EU compliance. CSA = Canadian standards.
|
UL, CSA, CE
|
|
Color
Button/actuator color. Green = start/go, Red = stop/emergency, Yellow = caution, Blue = reset (per IEC 60204-1).
|
Green + Red
|
|
Contact Configuration
1NO + 1NC: One circuit closes and one opens when pressed. Common for start buttons that also signal 'running' state.
|
1NO + 1NC
|
|
IP Rating
IP67: Dust-tight and survives temporary water submersion (1m for 30 min). Handles oil splashes, steam cleaning, and rain.
|
IP67
|
|
Mounting Type
How the button attaches to the panel. Panel mount is standard — installs through a cutout from the front.
|
Surface mount (enclosed)
|
|
Series
The manufacturer's product family. Products in the same series share mounting systems and accessories.
|
M22
|
설치 빠른 참조
Panel cutout: 22mm. Insert from the front of the panel, secure with mounting nut from behind (tighten to 2-3 Nm).
Contact block: Snap or screw the contact block onto the rear of the button body. Ensure the contact block orientation matches the wiring diagram — NO terminals are usually marked.
Wiring: Use 0.5-2.5mm² stranded wire with ferrules. Tighten screw terminals to 0.8 Nm. Test the button function before energizing the circuit.
외형 치수
배선도
문제 해결
Button doesn't respond when pressed
Check the contact block first — it's the most common failure point. Test continuity across the NO or NC terminals with a multimeter. If no click is felt, the return spring in the head may be broken.
Works intermittently
Contact block contacts are pitted or burned. Replace the contact block — don't try to file the contacts. Check if the rated cycle count has been exceeded.
Button feels mushy or doesn't click
The spring return mechanism in the button head is worn. Replace the head. The contact block can usually be reused if it tests OK.
주요 사양
- Certifications
- UL, CSA, CE
- Color
- Green + Red
- Contact Configuration
- 1NO + 1NC
- IP Rating
- IP67
- Mounting Type
- Surface mount (enclosed)
사용자 후기
“Eaton equivalent of the Schneider XALD211. Green start + red stop in IP67 enclosure. Surface-mount for remote motor control. Same M22 quality in a pre-built package.”