HW-C01
सक्रियHW 1NC Contact Block
IDEC HW series 1NC contact block.
सामान्य अनुप्रयोग
NC contact block for stop functions. Same IDEC value pricing. Keep spares — contact blocks are consumables.
स्पेसिफिकेशन
|
Certifications
Third-party safety certifications. UL = required for US NEC installations. CE = EU compliance. CSA = Canadian standards.
|
UL, CE
|
|
Contact Configuration
Normally Closed — circuit is on until you press. Standard for stop/emergency functions. Wire in series with safety circuits.
|
1NC
|
|
Mechanical Life
How many press cycles before mechanical failure. Higher is better — 10M cycles at 100 presses/day = 274 years.
|
10,000,000 cycles
|
|
Terminal Type
How you connect wires. Screw clamp is most common in industrial. Spring cage is faster but requires proper ferrules.
|
Screw clamp
|
इंस्टॉलेशन त्वरित संदर्भ
Mounting: Snap onto the rear of any compatible button body in the same series. The latch clicks audibly when properly seated. Some models require a mounting adapter.
Wiring: Terminals are marked NO (11/12) or NC (21/22). Use 0.5-2.5mm² wire with ferrules. Tighten to 0.8 Nm. Verify with a multimeter before energizing.
आयाम
वायरिंग डायग्राम
समस्या निवारण
Intermittent switching
Silver contacts are pitted from arcing. Replace the contact block — they are consumable parts. If arcing is severe, check that the switched load doesn't exceed the contact rating (typically 6A at 120VAC).
Contact block won't snap onto button body
Verify the contact block series matches the button head series (e.g., Schneider ZB4 blocks fit ZB4 heads only, not ZB5). Check for debris or damage on the mounting tabs.
कहाँ से खरीदें
मूल्य सीमा
$4.93 — $40.9
2 वितरकों से
संक्षिप्त स्पेसिफिकेशन
- Certifications
- UL, CE
- Contact Configuration
- 1NC
- Mechanical Life
- 10,000,000 cycles
- Terminal Type
- Screw clamp
उपयोगकर्ता क्या कह रहे हैं
“NC contact block for stop functions. Same IDEC value pricing. Keep spares — contact blocks are consumables.”