HW1B-M210R
Actif22mm Red Illuminated Flush 24V
IDEC HW series illuminated red flush push button.
Applications courantes
Budget illuminated red for fault acknowledge. IDEC offers the same illuminated function as Schneider or Eaton at 30-40% less cost. Good for budget panel builds where the customer is cost-conscious.
Spécifications
|
Actuator Function
Momentary = springs back when released. Maintained/latching = stays pressed until pressed again.
|
Momentary
|
|
Certifications
Third-party safety certifications. UL = required for US NEC installations. CE = EU compliance. CSA = Canadian standards.
|
UL, CE
|
|
Color
Button/actuator color. Green = start/go, Red = stop/emergency, Yellow = caution, Blue = reset (per IEC 60204-1).
|
Red
|
|
Contact Configuration
Normally Closed — circuit is on until you press. Standard for stop/emergency functions. Wire in series with safety circuits.
|
1NC
|
|
Cutout Diameter
The hole size you drill in your panel to mount this button. 22mm is the most common industrial standard worldwide.
|
22mm
|
|
Illumination
Whether the button has a built-in light. Illuminated buttons show status (lit = active).
|
Illuminated
|
|
IP Rating
IP65: Dust-tight and protected against low-pressure water jets. Suitable for indoor industrial and light washdown.
|
IP65
|
|
LED Voltage
The voltage required for the built-in LED. Must match your control circuit voltage (typically 24V DC or 230V AC).
|
24V DC
|
Référence rapide d'installation
Panel cutout: 22mm. Insert from the front of the panel, secure with mounting nut from behind (tighten to 2-3 Nm).
Contact block: Snap or screw the contact block onto the rear of the button body. Ensure the contact block orientation matches the wiring diagram — NO terminals are usually marked.
Wiring: Use 0.5-2.5mm² stranded wire with ferrules. Tighten screw terminals to 0.8 Nm. Test the button function before energizing the circuit.
Dimensions
Schéma de câblage
Dépannage
Button doesn't respond when pressed
Check the contact block first — it's the most common failure point. Test continuity across the NO or NC terminals with a multimeter. If no click is felt, the return spring in the head may be broken.
Works intermittently
Contact block contacts are pitted or burned. Replace the contact block — don't try to file the contacts. Check if the rated cycle count has been exceeded.
Button feels mushy or doesn't click
The spring return mechanism in the button head is worn. Replace the head. The contact block can usually be reused if it tests OK.
Où acheter
Fourchette de prix
$12.04 — $26.83
chez 3 distributeurs
Spécifications rapides
- Actuator Function
- Momentary
- Certifications
- UL, CE
- Color
- Red
- Contact Configuration
- 1NC
- Cutout Diameter
- 22mm
Ce qu'en disent les utilisateurs
“IDEC HW1B-M210R is a solid choice for push button applications. Standard specs, well-supported.”
En savoir plus
Indices de protection IP expliqués
Ce que signifient IP65, IP66, IP67, IP69K pour votre application
Guide 22mm vs 30mm
Quelle taille de découpe de panneau vous faut-il ?
Blocs de contact : NO vs NC
Comment choisir et câbler les blocs de contact
Outil de recherche de boutons
Trouvez le bon bouton par type, taille et couleur