IDEC · HW Seeria

HW1B-M110K

Aktiivne
UL CE

22mm Black Flush Push Button IDEC 1NO

Tootenumber: HW1B - M1
IDEC HW Seeria Introduced circa 2005

IDEC HW black push button.

Tüüpilised rakendused

Black auxiliary button. Completes the full IDEC color range.

Spetsifikatsioonid

Actuator Type
Flush
Certifications
UL, CE
Color
Black
Contact Configuration
1NO
Cutout Diameter
22mm
IP Rating
IP65

Paigalduse kiirjuhend

Panel cutout: 22mm. Insert from the front of the panel, secure with mounting nut from behind (tighten to 2-3 Nm).

Contact block: Snap or screw the contact block onto the rear of the button body. Ensure the contact block orientation matches the wiring diagram — NO terminals are usually marked.

Wiring: Use 0.5-2.5mm² stranded wire with ferrules. Tighten screw terminals to 0.8 Nm. Test the button function before energizing the circuit.

Mõõtmed

Front 22mm cutout panel hole diameter Side panel contact ~45mm depth

Ühenduseskeem

L T 11 12 NO (open) press ↓

Veaotsing

Button doesn't respond when pressed

Check the contact block first — it's the most common failure point. Test continuity across the NO or NC terminals with a multimeter. If no click is felt, the return spring in the head may be broken.

Works intermittently

Contact block contacts are pitted or burned. Replace the contact block — don't try to file the contacts. Check if the rated cycle count has been exceeded.

Button feels mushy or doesn't click

The spring return mechanism in the button head is worn. Replace the head. The contact block can usually be reused if it tests OK.

Kust osta

Hinnavahemik

$25.47 — $37.08

2 edasimüüja juures

Kiirspetsifikatsioonid

Actuator Type
Flush
Certifications
UL, CE
Color
Black
Contact Configuration
1NO
Cutout Diameter
22mm

Mida kasutajad ütlevad

+

“Black auxiliary button. Completes the full IDEC color range.”

Reddit r/PLC 34 poolthääli Vaata arutelu →