MPI002/28
Aktivní22mm Anti-Vandal IP67 Button
Bulgin 22mm anti-vandal push button in stainless steel with IP67 sealing.
Běžné aplikace
Designed for harsh public environments — transit stations, marine applications, outdoor kiosks, and defense equipment. Bulgin specializes in environmentally sealed connections, and this button carries that DNA with IP67 front-face protection and full stainless steel construction.
Specifikace
|
Actuator Function
Momentary = springs back when released. Maintained/latching = stays pressed until pressed again.
|
Momentary
|
|
Certifications
Third-party safety certifications. UL = required for US NEC installations. CE = EU compliance. CSA = Canadian standards.
|
CE
|
|
Contact Configuration
Normally Open — circuit is off until you press. Standard for start/go/enable functions.
|
1NO
|
|
Cutout Diameter
The hole size you drill in your panel to mount this button. 22mm is the most common industrial standard worldwide.
|
22mm
|
|
IP Rating
IP67: Dust-tight and survives temporary water submersion (1m for 30 min). Handles oil splashes, steam cleaning, and rain.
|
IP67
|
|
Material
The bezel/body material. Metal bezels are more durable in harsh environments. Plastic is lighter and cheaper.
|
Stainless Steel
|
|
Vandal Rating (IK)
IK rating for impact resistance. IK09 = 10 joules (hammer blow). IK10 = 20 joules (serious vandalism). Higher is tougher.
|
IK10
|
Specifikace s touto ikonou odkazují na původní stránku výrobce
Kompatibilní alternativy
Tyto produkty jsou funkčně ekvivalentní křížové reference od jiných výrobců.
Stručný průvodce instalací
Panel cutout: 22mm. Insert from the front of the panel, secure with mounting nut from behind (tighten to 2-3 Nm).
Contact block: Snap or screw the contact block onto the rear of the button body. Ensure the contact block orientation matches the wiring diagram — NO terminals are usually marked.
Wiring: Use 0.5-2.5mm² stranded wire with ferrules. Tighten screw terminals to 0.8 Nm. Test the button function before energizing the circuit.
Rozměry
Schéma zapojení
Řešení problémů
Button doesn't respond when pressed
Check the contact block first — it's the most common failure point. Test continuity across the NO or NC terminals with a multimeter. If no click is felt, the return spring in the head may be broken.
Works intermittently
Contact block contacts are pitted or burned. Replace the contact block — don't try to file the contacts. Check if the rated cycle count has been exceeded.
Button feels mushy or doesn't click
The spring return mechanism in the button head is worn. Replace the head. The contact block can usually be reused if it tests OK.
Kde koupit
Cenové rozpětí
$9.04 — $53.31
u 3 distributorů
Stručné specifikace
- Actuator Function
- Momentary
- Certifications
- CE
- Contact Configuration
- 1NO
- Cutout Diameter
- 22mm
- IP Rating
- IP67
Co říkají uživatelé
“Solid button for panel builds. Bulgin MPI002 series is well-proven in the field. Standard 22mm mounting means easy replacement if needed.”
Zjistit více
Zdroje dat
Specifikace a produktové údaje pocházejí z následujících zdrojů.
MPI002-28 Page
https://www.bulgin.com/products/range/switches/push-button.html
Zobrazeno April 04, 2026
