A01ESSP8

Aktivní

Apem A01ESSP8

APEM A01ESSP8 — Apem A01ESSP8

Emergency Stop Switches / E-Stop Switches 16MM IND CTRL E-STOP OPERATOR

Výzkumné poznámky

1. What this is

A01ESSP8 is an APEM A01/A02 pushbutton/indicator.

2. Part-number decode

  • Series: APEM A01/A02
  • Type: pushbutton
  • Ingress rating: IP65

3. Compatibility & ordering

APEM makes pushbuttons (incl. anti-vandal and illuminated), tactile switches, toggle switches, joysticks, and indicators for industrial and electronic equipment. Match by type, actuation, illumination, sealing (IP rating), and mounting, then use the APEM datasheet to confirm the exact contact and actuator configuration encoded in the part number.

4. Data-quality note

The APEM series and switch type are decoded from the part number (grounded in the apem.com catalog and distributor listings). The exact contact arrangement, illumination, and actuator/cap are encoded in the full order code — confirm against the APEM datasheet for a precise order (not guessed here).

5. Sources

  • APEM product catalog (apem.com)
  • Distributor listing (RS / Mouser / DigiKey) — search the exact part number

Zdroj
  1. APEM — A01ESSP8 — apem.com

Specifikace

Device class
pushbutton
Enriched by
apem-decoder-2026-08-12
Ingress rating
IP65
Lead time
140 Days
Manufacturer series
A01/A02
Mouser part number
642-A01ESSP8
Pn status
decoded
Rohs status
RoHS Compliant
Series description
APEM A01/A02-series pushbutton switch & indicator — panel-mount, sealed to IP65, single- to four-pole (a broad general-purpose command-switch range)

Stručný průvodce instalací

Panel cutout: 22mm. Mount with the yellow backing plate visible (required by EN/ISO 13850).

Wiring: Wire NC contacts in series with the safety relay input channels. Use dual-channel wiring for SIL 3 / PLe applications. Never wire directly to a motor contactor.

Testing: Press the e-stop and verify the machine stops within the required time. Test the reset mechanism. Repeat monthly per EN/ISO 13850.

Rozměry

Řešení problémů

E-stop won't reset (twist/pull doesn't release)

Check for debris in the mechanism. For twist-release: turn clockwise 45-90 degrees. For push-pull: pull straight out firmly. If the mechanism is stuck, the internal latch may be damaged — replace the entire head assembly.

Machine doesn't stop when e-stop is pressed

Critical safety issue. Immediately lock out the machine. Check wiring — NC contacts must be in series with the safety relay. Verify the safety relay is functioning. A broken wire in an NC circuit should cause a stop, so check for a wiring bypass.

Safety relay faults after e-stop reset

The safety relay detects a cross-fault between the two monitoring channels. Check that both NC contacts on the e-stop are switching simultaneously. One contact may be welded closed — replace the contact block.

Fotografie a výkresy

Obrázky: mouser.com

Stručné specifikace

Device class
pushbutton
Enriched by
apem-decoder-2026-08-12
Ingress rating
IP65
Lead time
140 Days
Manufacturer series
A01/A02