8LM2TB840
ActiveLovato 8LM2TB840 Red Mushroom E-Stop Actuator (8LM Platinum, twist-release, head-only)
Lovato 8LM emergency stop.
Common Applications
Italian e-stop. Competitive alternative to Schneider/ABB for European machine builders watching costs.
Specifications
|
Actuator Function
Momentary = springs back when released. Maintained/latching = stays pressed until pressed again.
|
Twist-release
|
|
Actuator Type
The button head style. Flush sits level with the bezel (prevents accidental presses). Extended protrudes for easy access.
|
Mushroom 40mm
|
|
Certifications
Third-party safety certifications. UL = required for US NEC installations. CE = EU compliance. CSA = Canadian standards.
|
CE, UL
|
|
Color
Button/actuator color. Green = start/go, Red = stop/emergency, Yellow = caution, Blue = reset (per IEC 60204-1).
|
Red
|
|
Contact Configuration
Normally Open — circuit is off until you press. Standard for start/go/enable functions.
|
None integral (mushroom ACTUATOR/head-only; add Lovato 8LM2TC NC contact element + holder)
|
|
Cutout Diameter
The hole size you drill in your panel to mount this button. 22mm is the most common industrial standard worldwide.
|
22mm
|
|
Device type
|
Lovato 8LM Platinum mushroom E-STOP actuator (Ø40 red, twist-release; head-only)
|
|
Pn note
|
8LM2TB is an ACTUATOR (head) — contact element separate (cf #477/#478). Stored 1NC misattributed; add NC element(s) per safety category. Type = red twist-release mushroom e-stop actuator.
|
Installation Quick Reference
Panel cutout: 22mm. Mount with the yellow backing plate visible (required by EN/ISO 13850).
Wiring: Wire NC contacts in series with the safety relay input channels. Use dual-channel wiring for SIL 3 / PLe applications. Never wire directly to a motor contactor.
Testing: Press the e-stop and verify the machine stops within the required time. Test the reset mechanism. Repeat monthly per EN/ISO 13850.
Dimensions
Wiring Diagram
Troubleshooting
E-stop won't reset (twist/pull doesn't release)
Check for debris in the mechanism. For twist-release: turn clockwise 45-90 degrees. For push-pull: pull straight out firmly. If the mechanism is stuck, the internal latch may be damaged — replace the entire head assembly.
Machine doesn't stop when e-stop is pressed
Critical safety issue. Immediately lock out the machine. Check wiring — NC contacts must be in series with the safety relay. Verify the safety relay is functioning. A broken wire in an NC circuit should cause a stop, so check for a wiring bypass.
Safety relay faults after e-stop reset
The safety relay detects a cross-fault between the two monitoring channels. Check that both NC contacts on the e-stop are switching simultaneously. One contact may be welded closed — replace the contact block.
Where to Buy
Price range
$26.47 — $166.24
across 2 distributors
Quick Specs
- Actuator Function
- Twist-release
- Actuator Type
- Mushroom 40mm
- Certifications
- CE, UL
- Color
- Red
- Contact Configuration
- None integral (mushroom ACTUATOR/head-only; add Lovato 8LM2TC NC contact element + holder)
What People Are Saying
“Italian e-stop. Competitive alternative to Schneider/ABB for European machine builders watching costs.”