1825910-7
在产FSM 6x6mm Tactile Switch SPST-NO
TE Connectivity 22mm anti-vandal push button.
常见应用
22mm version for standard industrial panel cutouts. Drop-in replacement for traditional 22mm push buttons when vandal resistance is needed. The ring LED provides clear visual feedback through the stainless bezel.
规格参数
|
Actuation Force
The force needed to press the button. Lower = more sensitive. Sanwa ~65g (light), Seimitsu ~85g (medium), Happ ~130g (heavy).
|
260 gf (base variant)
|
|
Actuator
|
Red round button
|
|
Actuator Function
Momentary = springs back when released. Maintained/latching = stays pressed until pressed again.
|
Momentary
|
|
Contact Configuration
Normally Open — circuit is off until you press. Standard for start/go/enable functions.
|
SPST-NO
|
|
IP Rating
IP67: Dust-tight and survives temporary water submersion (1m for 30 min). Handles oil splashes, steam cleaning, and rain.
|
IP67
|
|
Life cycles
|
100,000
|
|
Mount
|
Through-hole (THT), PCB
|
|
Operating temp
|
-35C to +85C
|
|
Rating
|
50 mA @ 24 VDC
|
|
Series
The manufacturer's product family. Products in the same series share mounting systems and accessories.
|
TE ALCOSWITCH FSM 6x6
|
安装快速参考
Panel cutout: 22mm. Insert from the front of the panel, secure with mounting nut from behind (tighten to 2-3 Nm).
Contact block: Snap or screw the contact block onto the rear of the button body. Ensure the contact block orientation matches the wiring diagram — NO terminals are usually marked.
Wiring: Use 0.5-2.5mm² stranded wire with ferrules. Tighten screw terminals to 0.8 Nm. Test the button function before energizing the circuit.
尺寸
接线图
故障排除
Button doesn't respond when pressed
Check the contact block first — it's the most common failure point. Test continuity across the NO or NC terminals with a multimeter. If no click is felt, the return spring in the head may be broken.
Works intermittently
Contact block contacts are pitted or burned. Replace the contact block — don't try to file the contacts. Check if the rated cycle count has been exceeded.
Button feels mushy or doesn't click
The spring return mechanism in the button head is worn. Replace the head. The contact block can usually be reused if it tests OK.
快速规格
- Actuation Force
- 260 gf (base variant)
- Actuator
- Red round button
- Actuator Function
- Momentary
- Contact Configuration
- SPST-NO
- IP Rating
- IP67
用户评价
“22mm version for standard industrial panel cutouts. Drop-in replacement for traditional 22mm push buttons when vandal resistance is needed. The ring LED provides clear visual feedback through the stai”
