Emergency Stop Switches / E-Stop Switches ESCR-B-2
Research Notes
1. What this is
605.1201.009 is an Altech component — series not recognized.
2. Part-number decode
- Series: Altech Altech (series not recognized)
3. Compatibility & ordering
Altech 22/30mm pushbuttons are cost-effective IEC-style panel operators. Match by size (22mm), operator material (metal vs plastic), illumination (and voltage), action, and contact blocks; cross-reference to Schneider Harmony, Allen-Bradley 800F, Siemens 3SU, or Eaton M22 by the same attributes if needed.
4. Data-quality note
The exact Altech series/configuration could not be confidently decoded from this part number. Kept and documented; flagged needs-verification rather than guessed.
5. Sources
- Altech Corp datasheet / 22mm pushbutton tech specs (altechcorp.com)
- Distributor listing (Mouser / Future Electronics) — search the exact part number
1 source
- Altech Corp — 605.1201.009 — altechcorp.com
Thông số kỹ thuật
|
Enriched by
|
altech-decoder-2026-08-12
|
|
Lead time
|
0 Days
|
|
Manufacturer series
|
Altech (series not recognized)
|
|
Mouser part number
|
845-605.1201.009
|
|
Pn status
|
needs-verification
|
|
Rohs status
|
|
|
Series description
|
Altech Corp industrial control component — exact series/config could not be decoded from this part number; kept and flagged for verification rather than guessed
|
Hướng Dẫn Cài Đặt Nhanh
Panel cutout: 22mm. Mount with the yellow backing plate visible (required by EN/ISO 13850).
Wiring: Wire NC contacts in series with the safety relay input channels. Use dual-channel wiring for SIL 3 / PLe applications. Never wire directly to a motor contactor.
Testing: Press the e-stop and verify the machine stops within the required time. Test the reset mechanism. Repeat monthly per EN/ISO 13850.
Kích thước
Khắc phục sự cố
E-stop won't reset (twist/pull doesn't release)
Check for debris in the mechanism. For twist-release: turn clockwise 45-90 degrees. For push-pull: pull straight out firmly. If the mechanism is stuck, the internal latch may be damaged — replace the entire head assembly.
Machine doesn't stop when e-stop is pressed
Critical safety issue. Immediately lock out the machine. Check wiring — NC contacts must be in series with the safety relay. Verify the safety relay is functioning. A broken wire in an NC circuit should cause a stop, so check for a wiring bypass.
Safety relay faults after e-stop reset
The safety relay detects a cross-fault between the two monitoring channels. Check that both NC contacts on the e-stop are switching simultaneously. One contact may be welded closed — replace the contact block.
Thông số kỹ thuật nhanh
- Enriched by
- altech-decoder-2026-08-12
- Lead time
- 0 Days
- Manufacturer series
- Altech (series not recognized)
- Mouser part number
- 845-605.1201.009
- Pn status
- needs-verification