AR22EOR-10R
AktifFuji AR22E0R-10R Red Extended Round Pushbutton 1NO
Fuji AR22 push-pull emergency stop.
Yaygın Uygulamalar
Push-pull e-stop for Fuji panels. Japanese standard.
Teknik Özellikler
|
Actuator Function
Momentary = springs back when released. Maintained/latching = stays pressed until pressed again.
|
Momentary
|
|
Actuator Type
The button head style. Flush sits level with the bezel (prevents accidental presses). Extended protrudes for easy access.
|
Extended (projecting) round head
|
|
Certifications
Third-party safety certifications. UL = required for US NEC installations. CE = EU compliance. CSA = Canadian standards.
|
JIS, UL, CE
|
|
Color
Button/actuator color. Green = start/go, Red = stop/emergency, Yellow = caution, Blue = reset (per IEC 60204-1).
|
Red
|
|
Contact Configuration
Normally Open — circuit is off until you press. Standard for start/go/enable functions.
|
1NO
|
|
Cutout Diameter
The hole size you drill in your panel to mount this button. 22mm is the most common industrial standard worldwide.
|
22mm
|
|
Device type
|
Fuji AR22 extended round momentary pushbutton (red, 1NO) — NOT an e-stop mushroom
|
|
Pn note
|
Corrected: AR22E0R-10R = EXTENDED round RED momentary pushbutton, 1NO (Radwell/AutomationDirect). Was mislabeled E-Stop push-pull mushroom 1NC. E=extended head; 10=1NO. Fuji e-stops use AR22V prefix (cf #475).
|
|
Pn status
|
mislabel-corrected
|
Hızlı Montaj Kılavuzu
Panel cutout: 22mm. Mount with the yellow backing plate visible (required by EN/ISO 13850).
Wiring: Wire NC contacts in series with the safety relay input channels. Use dual-channel wiring for SIL 3 / PLe applications. Never wire directly to a motor contactor.
Testing: Press the e-stop and verify the machine stops within the required time. Test the reset mechanism. Repeat monthly per EN/ISO 13850.
Boyutlar
Bağlantı Şeması
Sorun Giderme
E-stop won't reset (twist/pull doesn't release)
Check for debris in the mechanism. For twist-release: turn clockwise 45-90 degrees. For push-pull: pull straight out firmly. If the mechanism is stuck, the internal latch may be damaged — replace the entire head assembly.
Machine doesn't stop when e-stop is pressed
Critical safety issue. Immediately lock out the machine. Check wiring — NC contacts must be in series with the safety relay. Verify the safety relay is functioning. A broken wire in an NC circuit should cause a stop, so check for a wiring bypass.
Safety relay faults after e-stop reset
The safety relay detects a cross-fault between the two monitoring channels. Check that both NC contacts on the e-stop are switching simultaneously. One contact may be welded closed — replace the contact block.
Nereden Satın Alınır
Fiyat aralığı
$14.8 — $17.05
2 distribütörde
Kısa Teknik Özellikler
- Actuator Function
- Momentary
- Actuator Type
- Extended (projecting) round head
- Certifications
- JIS, UL, CE
- Color
- Red
- Contact Configuration
- 1NO
Kullanıcı Görüşleri
“Push-pull e-stop for Fuji panels. Japanese standard.”