800F-A3M1
ใช้งานอยู่800F Complete Green Extended Button 1NO
Allen-Bradley 800F extended (protruding) green push button.
การใช้งานทั่วไป
Extended button protrudes from panel surface — easier to find and press without looking. Used for cycle start on CNC machines and packaging lines where operators watch the product, not the panel. Complete unit with 1NO contact.
ข้อมูลจำเพาะ
|
Actuator Function
Momentary = springs back when released. Maintained/latching = stays pressed until pressed again.
|
Momentary
|
|
Actuator Type
The button head style. Flush sits level with the bezel (prevents accidental presses). Extended protrudes for easy access.
|
Extended
|
|
Certifications
Third-party safety certifications. UL = required for US NEC installations. CE = EU compliance. CSA = Canadian standards.
|
UL, CSA, CE
|
|
Color
Button/actuator color. Green = start/go, Red = stop/emergency, Yellow = caution, Blue = reset (per IEC 60204-1).
|
Green
|
|
Contact Configuration
Normally Open — circuit is off until you press. Standard for start/go/enable functions.
|
1NO
|
|
Cutout Diameter
The hole size you drill in your panel to mount this button. 22mm is the most common industrial standard worldwide.
|
22mm
|
|
IP Rating
IP66: Dust-tight and withstands powerful water jets from any direction. Standard for outdoor and washdown applications.
|
IP66
|
คู่มือการติดตั้งอย่างรวดเร็ว
Panel cutout: 22mm. Insert from the front of the panel, secure with mounting nut from behind (tighten to 2-3 Nm).
Contact block: Snap or screw the contact block onto the rear of the button body. Ensure the contact block orientation matches the wiring diagram — NO terminals are usually marked.
Wiring: Use 0.5-2.5mm² stranded wire with ferrules. Tighten screw terminals to 0.8 Nm. Test the button function before energizing the circuit.
ขนาด
แผนภาพการเดินสายไฟฟ้า
การแก้ไขปัญหา
Button doesn't respond when pressed
Check the contact block first — it's the most common failure point. Test continuity across the NO or NC terminals with a multimeter. If no click is felt, the return spring in the head may be broken.
Works intermittently
Contact block contacts are pitted or burned. Replace the contact block — don't try to file the contacts. Check if the rated cycle count has been exceeded.
Button feels mushy or doesn't click
The spring return mechanism in the button head is worn. Replace the head. The contact block can usually be reused if it tests OK.
สถานที่จำหน่าย
ช่วงราคา
$61.73 — $96.44
จาก 2 ผู้จัดจำหน่าย
ข้อมูลจำเพาะอย่างย่อ
- Actuator Function
- Momentary
- Actuator Type
- Extended
- Certifications
- UL, CSA, CE
- Color
- Green
- Contact Configuration
- 1NO
สิ่งที่ผู้คนพูดถึง
“Extended button protrudes from panel surface — easier to find and press without looking. Used for cycle start on CNC machines and packaging lines where operators watch the product, not the panel. Comp”