2AML4-NB

Ativo

Altech 2AML4-NB

Emergency Stop Switches / E-Stop Switches E-Stop Mush. Op.,22mm,Non Ill

Notas de Pesquisa

1. What this is

2AML4-NB is an Altech 2AM-series 22mm metal-operator pushbutton (metal command-switch operator).

2. Part-number decode

  • Series: Altech 2AM
  • Operator material: Metal

3. Compatibility & ordering

Altech 22/30mm pushbuttons are cost-effective IEC-style panel operators. Match by size (22mm), operator material (metal vs plastic), illumination (and voltage), action, and contact blocks; cross-reference to Schneider Harmony, Allen-Bradley 800F, Siemens 3SU, or Eaton M22 by the same attributes if needed.

4. Data-quality note

The Altech series family is identified, but the exact operator style/contact config is not fully determinable from the part number alone — treat as indicative and confirm against Altech's datasheet. Flagged decoded-partial.

5. Sources

  • Altech Corp datasheet / 22mm pushbutton tech specs (altechcorp.com)
  • Distributor listing (Mouser / Future Electronics) — search the exact part number

Fonte
  1. Altech Corp — 2AML4-NB — altechcorp.com

Especificações

Device class
pushbutton
Enriched by
altech-decoder-2026-08-12
Lead time
0 Days
Manufacturer series
2AM
Mouser part number
845-2AML4NB
Operator material
metal
Pn status
decoded-partial
Rohs status
Series description
Altech 2AM-series 22mm metal-operator pushbutton (metal command-switch operator)

Referência rápida de instalação

Panel cutout: 22mm. Mount with the yellow backing plate visible (required by EN/ISO 13850).

Wiring: Wire NC contacts in series with the safety relay input channels. Use dual-channel wiring for SIL 3 / PLe applications. Never wire directly to a motor contactor.

Testing: Press the e-stop and verify the machine stops within the required time. Test the reset mechanism. Repeat monthly per EN/ISO 13850.

Dimensões

Solução de problemas

E-stop won't reset (twist/pull doesn't release)

Check for debris in the mechanism. For twist-release: turn clockwise 45-90 degrees. For push-pull: pull straight out firmly. If the mechanism is stuck, the internal latch may be damaged — replace the entire head assembly.

Machine doesn't stop when e-stop is pressed

Critical safety issue. Immediately lock out the machine. Check wiring — NC contacts must be in series with the safety relay. Verify the safety relay is functioning. A broken wire in an NC circuit should cause a stop, so check for a wiring bypass.

Safety relay faults after e-stop reset

The safety relay detects a cross-fault between the two monitoring channels. Check that both NC contacts on the e-stop are switching simultaneously. One contact may be welded closed — replace the contact block.

Especificações rápidas

Device class
pushbutton
Enriched by
altech-decoder-2026-08-12
Lead time
0 Days
Manufacturer series
2AM
Mouser part number
845-2AML4NB