ZBMINIL2
AktywnySONOFF ZBMINI L2 Zigbee Smart Switch (No Neutral)
SONOFF ZBMINI L2 — converts any wall switch to Zigbee smart, no neutral wire needed.
Typowe Zastosowania
Installs behind your existing wall switch. No neutral wire required — works with just live and load. Converts any dumb toggle or momentary switch into a Zigbee smart switch. The existing switch becomes a physical trigger while the ZBMINI controls the load. Solves the retrofit problem for homes without neutral wires at the switch box.
Otwartość i Modyfikowalność
Firmware niestandardowy: Zigbee2MQTT (native), Tasmota (via serial flash on WiFi variant)
Full Z2M support. The Zigbee version works natively with any Zigbee coordinator. No cloud required. The WiFi variant (MINI R4) can be flashed with Tasmota for full local control.
Specyfikacje
|
Certifications
Third-party safety certifications. UL = required for US NEC installations. CE = EU compliance. CSA = Canadian standards.
|
CE, FCC
|
|
Mounting Type
How the button attaches to the panel. Panel mount is standard — installs through a cutout from the front.
|
Behind existing wall switch (no neutral required)
|
|
Protocol
The wireless communication standard. BLE = short range, phone direct. Zigbee = mesh network, needs hub. Z-Wave = mesh, needs hub. WiFi = direct, higher power.
|
Zigbee 3.0
|
Skrócona Instrukcja Montażu
Setup: Pair with your hub or phone via Zigbee 3.0. Most smart buttons support single press, double press, and long press for three different actions.
Battery: Uses CR2032 battery. Expected life: 1-2 years. Low battery notification via the app.
Wymiary
Rozwiązywanie Problemów
Not responding to input
Check wiring continuity with a multimeter. Verify the contact block is properly seated. Inspect terminals for loose connections.
Gdzie Kupić
Przedział cenowy
$16.42 — $87.82
u 2 dystrybutorów
Skrócone Specyfikacje
- Certifications
- CE, FCC
- Mounting Type
- Behind existing wall switch (no neutral required)
- Protocol
- Zigbee 3.0
Co Mówią Użytkownicy
“Full Z2M support. The Zigbee version works natively with any Zigbee coordinator. No cloud required. The WiFi variant (MINI R4) can be flashed with Tasmota for full local control.”
