FDM-1
AktywnyFDM-1 Dual Action Fire Alarm Pull Station
Notifier FDM-1 dual-action pull station — lift then pull.
Typowe Zastosowania
Dual-action pull station — requires lifting a cover then pulling the handle. Reduces false alarms from accidental bumps. Required by some building codes in schools and dormitories. ADA compliant. Same SLC addressable protocol as NBG-12LX.
Specyfikacje
|
Actuator Function
Momentary = springs back when released. Maintained/latching = stays pressed until pressed again.
|
Lift cover, then pull handle
|
|
ADA Compliant
Meets Americans with Disabilities Act requirements for accessible design.
|
Yes
|
|
Certifications
Third-party safety certifications. UL = required for US NEC installations. CE = EU compliance. CSA = Canadian standards.
|
UL 38, UL 864, CSFM
|
|
Color
Button/actuator color. Green = start/go, Red = stop/emergency, Yellow = caution, Blue = reset (per IEC 60204-1).
|
Red
|
|
Contact Configuration
The electrical switching arrangement.
|
Addressable (SLC loop)
|
Skrócona Instrukcja Montażu
Panel cutout: 22mm. Insert from the front of the panel, secure with mounting nut from behind (tighten to 2-3 Nm).
Contact block: Snap or screw the contact block onto the rear of the button body. Ensure the contact block orientation matches the wiring diagram — NO terminals are usually marked.
Wiring: Use 0.5-2.5mm² stranded wire with ferrules. Tighten screw terminals to 0.8 Nm. Test the button function before energizing the circuit.
Wymiary
Schemat Połączeń
Rozwiązywanie Problemów
Button doesn't respond when pressed
Check the contact block first — it's the most common failure point. Test continuity across the NO or NC terminals with a multimeter. If no click is felt, the return spring in the head may be broken.
Works intermittently
Contact block contacts are pitted or burned. Replace the contact block — don't try to file the contacts. Check if the rated cycle count has been exceeded.
Button feels mushy or doesn't click
The spring return mechanism in the button head is worn. Replace the head. The contact block can usually be reused if it tests OK.
Gdzie Kupić
Przedział cenowy
$82.68 — $83.57
u 2 dystrybutorów
Skrócone Specyfikacje
- Actuator Function
- Lift cover, then pull handle
- ADA Compliant
- Yes
- Certifications
- UL 38, UL 864, CSFM
- Color
- Red
- Contact Configuration
- Addressable (SLC loop)
Co Mówią Użytkownicy
“Dual-action pull station — requires lifting a cover then pulling the handle. Reduces false alarms from accidental bumps. Required by some building codes in schools and dormitories. ADA compliant. Same”
Dowiedz się Więcej
Objaśnienie Klasyfikacji IP
Co oznaczają IP65, IP66, IP67, IP69K dla Państwa zastosowania
Przewodnik 22mm vs 30mm
Jakiego rozmiaru otworu montażowego potrzebujesz?
Bloki Styków: NO vs NC
Jak wybrać i podłączyć bloki styków
Narzędzie Wyszukiwania Przycisków
Znajdź właściwy przycisk wg typu, rozmiaru i koloru