8LM2TIL103
AktywnyLovato 8LM2TIL103 Green Pilot Light Head 24V (8LM Platinum)
Lovato 8LM illuminated green.
Typowe Zastosowania
Italian illuminated start button. Budget alternative.
Specyfikacje
|
Certifications
Third-party safety certifications. UL = required for US NEC installations. CE = EU compliance. CSA = Canadian standards.
|
CE, UL
|
|
Color
Button/actuator color. Green = start/go, Red = stop/emergency, Yellow = caution, Blue = reset (per IEC 60204-1).
|
Green
|
|
Contact Configuration
Normally Open — circuit is off until you press. Standard for start/go/enable functions.
|
None (indicator light — no switching contact)
|
|
Cutout Diameter
The hole size you drill in your panel to mount this button. 22mm is the most common industrial standard worldwide.
|
22mm
|
|
Device type
|
Lovato 8LM Platinum pilot (indicator) LIGHT head (green, 24V) — NOT a pushbutton
|
|
Illumination
Whether the button has a built-in light. Illuminated buttons show status (lit = active).
|
Illuminated
|
|
LED Voltage
The voltage required for the built-in LED. Must match your control circuit voltage (typically 24V DC or 230V AC).
|
24V AC/DC
|
|
Pn note
|
Corrected: 8LM2TIL103 = green PILOT LIGHT head (Lovato/Galco), not an illuminated pushbutton. 8LM code TIL=pilot light (TB=pushbutton). No contact (stored 1NO wrong).
|
|
Pn status
|
mislabel-corrected
|
Skrócona Instrukcja Montażu
Panel cutout: 22mm. Insert from the front of the panel, secure with mounting nut from behind (tighten to 2-3 Nm).
Contact block: Snap or screw the contact block onto the rear of the button body. Ensure the contact block orientation matches the wiring diagram — NO terminals are usually marked.
Wiring: Use 0.5-2.5mm² stranded wire with ferrules. Tighten screw terminals to 0.8 Nm. Test the button function before energizing the circuit.
Wymiary
Schemat Połączeń
Rozwiązywanie Problemów
Button doesn't respond when pressed
Check the contact block first — it's the most common failure point. Test continuity across the NO or NC terminals with a multimeter. If no click is felt, the return spring in the head may be broken.
Works intermittently
Contact block contacts are pitted or burned. Replace the contact block — don't try to file the contacts. Check if the rated cycle count has been exceeded.
Button feels mushy or doesn't click
The spring return mechanism in the button head is worn. Replace the head. The contact block can usually be reused if it tests OK.
Gdzie Kupić
Przedział cenowy
$13.87 — $35.2
u 2 dystrybutorów
Skrócone Specyfikacje
- Certifications
- CE, UL
- Color
- Green
- Contact Configuration
- None (indicator light — no switching contact)
- Cutout Diameter
- 22mm
- Device type
- Lovato 8LM Platinum pilot (indicator) LIGHT head (green, 24V) — NOT a pushbutton
Co Mówią Użytkownicy
“Italian illuminated start button. Budget alternative.”
Dowiedz się Więcej
Objaśnienie Klasyfikacji IP
Co oznaczają IP65, IP66, IP67, IP69K dla Państwa zastosowania
Przewodnik 22mm vs 30mm
Jakiego rozmiaru otworu montażowego potrzebujesz?
Bloki Styków: NO vs NC
Jak wybrać i podłączyć bloki styków
Narzędzie Wyszukiwania Przycisków
Znajdź właściwy przycisk wg typu, rozmiaru i koloru
Więcej od Lovato Electric
Lovato Electric
8LM2TB103
Lovato 8LM2TB103 Green Flush Pushbutton Actuator (8LM Platinum, head-only)
Lovato Electric
8LM2TB104
Lovato 8LM2TB104 Red Flush Pushbutton Actuator (8LM Platinum, head-only)
Lovato Electric
8LM2TB105
Lovato 8LM2TB105 Yellow Flush Pushbutton Actuator (8LM Platinum, head-only)