BZ-2RW82
AktywnyBZ Heavy Duty Limit Switch
Honeywell BZ heavy-duty limit switch with roller lever.
Typowe Zastosowania
Industrial limit switch used as position sensor on machine tools, conveyors, and automated equipment. The roller lever activates when the machine reaches a set position — end-of-travel, door closed, part present. Not a push button per se, but uses the same snap-action microswitch technology internally.
Specyfikacje
|
Actuator Function
Momentary = springs back when released. Maintained/latching = stays pressed until pressed again.
|
Roller lever
|
|
Certifications
Third-party safety certifications. UL = required for US NEC installations. CE = EU compliance. CSA = Canadian standards.
|
UL, CSA, CE
|
|
Contact Configuration
The electrical switching arrangement.
|
SPDT
|
|
IP Rating
IP67: Dust-tight and survives temporary water submersion (1m for 30 min). Handles oil splashes, steam cleaning, and rain.
|
IP67
|
|
Material
The bezel/body material. Metal bezels are more durable in harsh environments. Plastic is lighter and cheaper.
|
Die-cast zinc housing
|
|
Mechanical Life
How many press cycles before mechanical failure. Higher is better — 10M cycles at 100 presses/day = 274 years.
|
10,000,000 cycles
|
|
Operating Force
Maximum force needed to press. ADA requires ≤5 lbs (22.2N) for accessibility.
|
4.5N
|
Skrócona Instrukcja Montażu
Panel cutout: 22mm. Insert from the front of the panel, secure with mounting nut from behind (tighten to 2-3 Nm).
Contact block: Snap or screw the contact block onto the rear of the button body. Ensure the contact block orientation matches the wiring diagram — NO terminals are usually marked.
Wiring: Use 0.5-2.5mm² stranded wire with ferrules. Tighten screw terminals to 0.8 Nm. Test the button function before energizing the circuit.
Wymiary
Schemat Połączeń
Rozwiązywanie Problemów
Button doesn't respond when pressed
Check the contact block first — it's the most common failure point. Test continuity across the NO or NC terminals with a multimeter. If no click is felt, the return spring in the head may be broken.
Works intermittently
Contact block contacts are pitted or burned. Replace the contact block — don't try to file the contacts. Check if the rated cycle count has been exceeded.
Button feels mushy or doesn't click
The spring return mechanism in the button head is worn. Replace the head. The contact block can usually be reused if it tests OK.
Gdzie Kupić
Przedział cenowy
$3.48 — $6.26
u 2 dystrybutorów
Skrócone Specyfikacje
- Actuator Function
- Roller lever
- Certifications
- UL, CSA, CE
- Contact Configuration
- SPDT
- IP Rating
- IP67
- Material
- Die-cast zinc housing
Co Mówią Użytkownicy
“Industrial limit switch used as position sensor on machine tools, conveyors, and automated equipment. The roller lever activates when the machine reaches a set position — end-of-tr”
Dowiedz się Więcej
Objaśnienie Klasyfikacji IP
Co oznaczają IP65, IP66, IP67, IP69K dla Państwa zastosowania
Przewodnik 22mm vs 30mm
Jakiego rozmiaru otworu montażowego potrzebujesz?
Bloki Styków: NO vs NC
Jak wybrać i podłączyć bloki styków
Narzędzie Wyszukiwania Przycisków
Znajdź właściwy przycisk wg typu, rozmiaru i koloru
