XB5RMA02
현행 제품Harmony XB5R Wireless Push Button Green
Schneider Harmony XB5R — wireless push button requiring no wiring or batteries.
일반적인 용도
Battery-free wireless push button using energy harvesting — the mechanical energy from pressing the button powers the radio transmission. No wires, no batteries, zero maintenance. Uses Schneiders proprietary 868/915MHz protocol with ZB5RTA receiver. IP66 rated. Mount anywhere without running conduit. The future of industrial push buttons.
사양 목록
|
Actuator Function
Momentary = springs back when released. Maintained/latching = stays pressed until pressed again.
|
Momentary
|
|
Battery Type
The battery used. CR2032 = common coin cell, easy to replace. AAA = higher capacity. USB-C = rechargeable.
|
None (kinetic)
|
|
Certifications
Third-party safety certifications. UL = required for US NEC installations. CE = EU compliance. CSA = Canadian standards.
|
CE, FCC
|
|
Color
Button/actuator color. Green = start/go, Red = stop/emergency, Yellow = caution, Blue = reset (per IEC 60204-1).
|
Green
|
|
Cutout Diameter
The hole size you drill in your panel to mount this button. 22mm is the most common industrial standard worldwide.
|
22mm
|
|
IP Rating
IP66: Dust-tight and withstands powerful water jets from any direction. Standard for outdoor and washdown applications.
|
IP66
|
|
Protocol
The wireless communication standard. BLE = short range, phone direct. Zigbee = mesh network, needs hub. Z-Wave = mesh, needs hub. WiFi = direct, higher power.
|
868/915MHz (energy harvesting)
|
|
Wireless Range
Maximum wireless range in open air. Walls and interference reduce this significantly.
|
25m indoors, 100m outdoors
|
설치 빠른 참조
Panel cutout: 22mm. Insert from the front of the panel, secure with mounting nut from behind (tighten to 2-3 Nm).
Contact block: Snap or screw the contact block onto the rear of the button body. Ensure the contact block orientation matches the wiring diagram — NO terminals are usually marked.
Wiring: Use 0.5-2.5mm² stranded wire with ferrules. Tighten screw terminals to 0.8 Nm. Test the button function before energizing the circuit.
외형 치수
문제 해결
Button doesn't respond when pressed
Check the contact block first — it's the most common failure point. Test continuity across the NO or NC terminals with a multimeter. If no click is felt, the return spring in the head may be broken.
Works intermittently
Contact block contacts are pitted or burned. Replace the contact block — don't try to file the contacts. Check if the rated cycle count has been exceeded.
Button feels mushy or doesn't click
The spring return mechanism in the button head is worn. Replace the head. The contact block can usually be reused if it tests OK.
주요 사양
- Actuator Function
- Momentary
- Battery Type
- None (kinetic)
- Certifications
- CE, FCC
- Color
- Green
- Cutout Diameter
- 22mm
사용자 후기
“Battery-free wireless push button using energy harvesting — the mechanical energy from pressing the button powers the radio transmission. No wires, no batteries, zero maintenance. Uses Schneiders prop”
