A22-10
현행 제품A22 1NO Contact Block
Omron A22 1NO contact block.
일반적인 용도
Native Omron contact block for the A22 series. If your panel has Omron buttons, use Omron contact blocks for guaranteed compatibility.
사양 목록
|
Certifications
Third-party safety certifications. UL = required for US NEC installations. CE = EU compliance. CSA = Canadian standards.
|
UL, CE
|
|
Contact Configuration
Normally Open — circuit is off until you press. Standard for start/go/enable functions.
|
1NO
|
|
Mechanical Life
How many press cycles before mechanical failure. Higher is better — 10M cycles at 100 presses/day = 274 years.
|
10,000,000 cycles
|
|
Terminal Type
How you connect wires. Screw clamp is most common in industrial. Spring cage is faster but requires proper ferrules.
|
Screw clamp
|
설치 빠른 참조
Mounting: Snap onto the rear of any compatible button body in the same series. The latch clicks audibly when properly seated. Some models require a mounting adapter.
Wiring: Terminals are marked NO (11/12) or NC (21/22). Use 0.5-2.5mm² wire with ferrules. Tighten to 0.8 Nm. Verify with a multimeter before energizing.
외형 치수
배선도
문제 해결
Intermittent switching
Silver contacts are pitted from arcing. Replace the contact block — they are consumable parts. If arcing is severe, check that the switched load doesn't exceed the contact rating (typically 6A at 120VAC).
Contact block won't snap onto button body
Verify the contact block series matches the button head series (e.g., Schneider ZB4 blocks fit ZB4 heads only, not ZB5). Check for debris or damage on the mounting tabs.
구매처
가격 범위
$7.78 — $67.55
3개 대리점
주요 사양
- Certifications
- UL, CE
- Contact Configuration
- 1NO
- Mechanical Life
- 10,000,000 cycles
- Terminal Type
- Screw clamp
사용자 후기
“Native Omron contact block for the A22 series. If your panel has Omron buttons, use Omron contact blocks for guaranteed compatibility.”