Emergency Stop Switches / E-Stop Switches ESTOP PUSHPULL 1N/O+1N/C
Research Notes
1. What this is
XB7NT845 is a Schneider Electric Harmony XB7 economy complete 22mm pushbutton (monolithic, integral contact).
2. Part-number decode
- Series: Harmony XB7
- Panel cutout: 22mm
- Bezel material: Plastic
- Type: complete unit
3. Compatibility & ordering
Schneider's Harmony (22/16mm) and Square D Class 9001 (30mm) are the reference IEC/US command-switch ranges. This is a complete, pre-assembled device (operator + contact block). Match by size (16/22/30mm), bezel material (metal XB4/ZB4 vs plastic XB5/ZB5), function (pushbutton/selector/indicator/E-stop), colour, illumination, and contact arrangement; cross-reference to Allen-Bradley 800F/800T, Siemens 3SU, IDEC HW, or Eaton M22 by the same attributes if needed.
4. Data-quality note
The Schneider series/family is identified; bezel/size are indicative and the exact colour/contact configuration is left to the Schneider datasheet rather than guessed. Flagged decoded-partial.
5. Sources
- Schneider Electric Harmony / Square D Class 9001 catalog (se.com)
- Distributor listing (Rexel / Mouser / Newark) — search the exact part number
1 source
- Schneider Electric — XB7NT845 — se.com
仕様一覧
|
Bezel material
|
plastic
|
|
Component type
|
complete unit
|
|
Enriched by
|
schneider-decoder-2026-08-12
|
|
Lead time
|
18 Days
|
|
Manufacturer series
|
Harmony XB7
|
|
Mouser part number
|
996-XB7NT845
|
|
Panel cutout
|
22mm
|
|
Pn status
|
decoded-partial
|
|
Wireless Range
Maximum wireless range in open air. Walls and interference reduce this significantly.
|
Harmony / Square D Class 9001
|
|
Rohs status
|
|
|
Series description
|
Schneider Harmony XB7 economy complete 22mm pushbutton (monolithic, integral contact)
|
取付クイックリファレンス
Panel cutout: 22mm. Mount with the yellow backing plate visible (required by EN/ISO 13850).
Wiring: Wire NC contacts in series with the safety relay input channels. Use dual-channel wiring for SIL 3 / PLe applications. Never wire directly to a motor contactor.
Testing: Press the e-stop and verify the machine stops within the required time. Test the reset mechanism. Repeat monthly per EN/ISO 13850.
外形寸法
トラブルシューティング
E-stop won't reset (twist/pull doesn't release)
Check for debris in the mechanism. For twist-release: turn clockwise 45-90 degrees. For push-pull: pull straight out firmly. If the mechanism is stuck, the internal latch may be damaged — replace the entire head assembly.
Machine doesn't stop when e-stop is pressed
Critical safety issue. Immediately lock out the machine. Check wiring — NC contacts must be in series with the safety relay. Verify the safety relay is functioning. A broken wire in an NC circuit should cause a stop, so check for a wiring bypass.
Safety relay faults after e-stop reset
The safety relay detects a cross-fault between the two monitoring channels. Check that both NC contacts on the e-stop are switching simultaneously. One contact may be welded closed — replace the contact block.
主要仕様
- Bezel material
- plastic
- Component type
- complete unit
- Enriched by
- schneider-decoder-2026-08-12
- Lead time
- 18 Days
- Manufacturer series
- Harmony XB7
