PLB06K
現行品PLB06 Crane Pendant 6-Button Station
Giovenzana PLB06 6-button pendant control station for overhead cranes.
主な用途
The pendant controller hanging from the cable on every overhead crane. 6 buttons: up/down/east/west for bridge and trolley, plus e-stop. IP65 sealed. Yellow housing per EN 60204. If you have operated a crane in Europe, you have held this pendant.
仕様一覧
|
Actuator Function
Momentary = springs back when released. Maintained/latching = stays pressed until pressed again.
|
Momentary
|
|
Certifications
Third-party safety certifications. UL = required for US NEC installations. CE = EU compliance. CSA = Canadian standards.
|
CE, IEC 60947-5-1
|
|
Color
Button/actuator color. Green = start/go, Red = stop/emergency, Yellow = caution, Blue = reset (per IEC 60204-1).
|
Yellow housing
|
|
Contact Configuration
Normally Open — circuit is off until you press. Standard for start/go/enable functions.
|
6x 1NO (momentary)
|
|
IP Rating
IP65: Dust-tight and protected against low-pressure water jets. Suitable for indoor industrial and light washdown.
|
IP65
|
|
Material
The bezel/body material. Metal bezels are more durable in harsh environments. Plastic is lighter and cheaper.
|
Polycarbonate housing
|
取付クイックリファレンス
Panel cutout: 22mm. Insert from the front of the panel, secure with mounting nut from behind (tighten to 2-3 Nm).
Contact block: Snap or screw the contact block onto the rear of the button body. Ensure the contact block orientation matches the wiring diagram — NO terminals are usually marked.
Wiring: Use 0.5-2.5mm² stranded wire with ferrules. Tighten screw terminals to 0.8 Nm. Test the button function before energizing the circuit.
外形寸法
配線図
トラブルシューティング
Button doesn't respond when pressed
Check the contact block first — it's the most common failure point. Test continuity across the NO or NC terminals with a multimeter. If no click is felt, the return spring in the head may be broken.
Works intermittently
Contact block contacts are pitted or burned. Replace the contact block — don't try to file the contacts. Check if the rated cycle count has been exceeded.
Button feels mushy or doesn't click
The spring return mechanism in the button head is worn. Replace the head. The contact block can usually be reused if it tests OK.
主要仕様
- Actuator Function
- Momentary
- Certifications
- CE, IEC 60947-5-1
- Color
- Yellow housing
- Contact Configuration
- 6x 1NO (momentary)
- IP Rating
- IP65
ユーザーの声
“The pendant controller hanging from the cable on every overhead crane. 6 buttons: up/down/east/west for bridge and trolley, plus e-stop. IP65 sealed. Yellow housing per EN 60204. If you have operated ”