PA512C

現行品

E-Switch PA512C

E-Switch PA512C — E-Switch PA512C

Pushbutton Switches 16A 125/250VAC Off-On2 Pole

研究ノート

1. What this is

PA512C is an E-Switch E-Switch component — line not recognized.

2. Part-number decode

  • Series: E-Switch E-Switch (line not recognized)
  • Type: switch

3. Compatibility & ordering

E-Switch makes tactile, pushbutton (incl. anti-vandal/illuminated), toggle, slide, and appliance switches for electronics and industrial controls. Match by type, actuation (momentary/maintained), illumination, sealing, and mounting, then use the E-Switch datasheet to confirm the exact contact form and termination encoded in the part number.

4. Data-quality note

The exact E-Switch product line/configuration could not be confidently decoded from this part number. Kept and documented; flagged needs-verification.

5. Sources

  • E-Switch product catalog (e-switch.com)
  • Distributor listing (DigiKey / Mouser) — search the exact part number

出典
  1. E-Switch — PA512C — e-switch.com

仕様一覧

Enriched by
eswitch-decoder-2026-08-12
Lead time
78 Days
Manufacturer series
E-Switch (line not recognized)
Mouser part number
612-PA512C
Pn status
needs-verification
Rohs status
RoHS Compliant
Series description
E-Switch component — exact product line/config could not be decoded from this part number; kept and flagged for verification rather than guessed

取付クイックリファレンス

Panel cutout: 22mm. Insert from the front of the panel, secure with mounting nut from behind (tighten to 2-3 Nm).

Contact block: Snap or screw the contact block onto the rear of the button body. Ensure the contact block orientation matches the wiring diagram — NO terminals are usually marked.

Wiring: Use 0.5-2.5mm² stranded wire with ferrules. Tighten screw terminals to 0.8 Nm. Test the button function before energizing the circuit.

外形寸法

トラブルシューティング

Button doesn't respond when pressed

Check the contact block first — it's the most common failure point. Test continuity across the NO or NC terminals with a multimeter. If no click is felt, the return spring in the head may be broken.

Works intermittently

Contact block contacts are pitted or burned. Replace the contact block — don't try to file the contacts. Check if the rated cycle count has been exceeded.

Button feels mushy or doesn't click

The spring return mechanism in the button head is worn. Replace the head. The contact block can usually be reused if it tests OK.

写真と図面

画像: mouser.com

主要仕様

Enriched by
eswitch-decoder-2026-08-12
Lead time
78 Days
Manufacturer series
E-Switch (line not recognized)
Mouser part number
612-PA512C
Pn status
needs-verification