MKS1-10
現行品22mm 2-Position Key Switch 1NO
ABB MK series 2-position key-operated selector.
主な用途
Key switch for ABB panel mode protection. Prevents unauthorized mode changes. Supervisor holds the key. Used on VFD panels for local/remote control and on robot cells for teach/auto mode.
仕様一覧
|
Actuator Function
Momentary = springs back when released. Maintained/latching = stays pressed until pressed again.
|
Maintained, key removable in both positions
|
|
Certifications
Third-party safety certifications. UL = required for US NEC installations. CE = EU compliance. CSA = Canadian standards.
|
UL, CSA, CE
|
|
Contact Configuration
Normally Open — circuit is off until you press. Standard for start/go/enable functions.
|
1NO
|
|
Cutout Diameter
The hole size you drill in your panel to mount this button. 22mm is the most common industrial standard worldwide.
|
22mm
|
|
IP Rating
IP66: Dust-tight and withstands powerful water jets from any direction. Standard for outdoor and washdown applications.
|
IP66
|
取付クイックリファレンス
Panel cutout: 22mm. Align the selector positions with the desired panel markings before tightening.
Contact blocks: Attach one contact block per position. Wire each to a separate PLC input for position feedback. A 2-position switch needs 1-2 blocks; 3-position needs 2-3.
外形寸法
配線図
トラブルシューティング
Not responding to input
Check wiring continuity with a multimeter. Verify the contact block is properly seated. Inspect terminals for loose connections.
主要仕様
- Actuator Function
- Maintained, key removable in both positions
- Certifications
- UL, CSA, CE
- Contact Configuration
- 1NO
- Cutout Diameter
- 22mm
- IP Rating
- IP66
ユーザーの声
“Key switch for ABB panel mode protection. Prevents unauthorized mode changes. Supervisor holds the key. Used on VFD panels for local/remote control and on robot cells for teach/auto mode.”