Emergency Stop Switches / E-Stop Switches Emergency stop switch, 32 mm, mushroom-head, illuminative, Red, Plastic, opaque, 2 NC, Maintained, Plug-interminal, 2.8 x 0.5 mm, IP65, IP66, IP67, Twist to unlock, Red / Green
Specifiche
|
Lead time
|
33 Days
|
|
Mouser part number
|
123-84-5341.8D20
|
|
Rohs status
|
RoHS Compliant
|
Guida Rapida all'Installazione
Panel cutout: 22mm. Mount with the yellow backing plate visible (required by EN/ISO 13850).
Wiring: Wire NC contacts in series with the safety relay input channels. Use dual-channel wiring for SIL 3 / PLe applications. Never wire directly to a motor contactor.
Testing: Press the e-stop and verify the machine stops within the required time. Test the reset mechanism. Repeat monthly per EN/ISO 13850.
Dimensioni
Risoluzione dei Problemi
E-stop won't reset (twist/pull doesn't release)
Check for debris in the mechanism. For twist-release: turn clockwise 45-90 degrees. For push-pull: pull straight out firmly. If the mechanism is stuck, the internal latch may be damaged — replace the entire head assembly.
Machine doesn't stop when e-stop is pressed
Critical safety issue. Immediately lock out the machine. Check wiring — NC contacts must be in series with the safety relay. Verify the safety relay is functioning. A broken wire in an NC circuit should cause a stop, so check for a wiring bypass.
Safety relay faults after e-stop reset
The safety relay detects a cross-fault between the two monitoring channels. Check that both NC contacts on the e-stop are switching simultaneously. One contact may be welded closed — replace the contact block.
Dove Acquistare
Fascia di prezzo
$80.64 — $80.64
presso 1 distributori
Specifiche Rapide
- Lead time
- 33 Days
- Mouser part number
- 123-84-5341.8D20
- Rohs status
- RoHS Compliant
