800T-A2A
सक्रिय800T 30mm Red Flush Push Button 1NC
Allen-Bradley 800T heavy-duty 30mm red push button.
सामान्य अनुप्रयोग
Legacy 30mm stop button found on older North American machinery. The 800T series was the standard before the 22mm 800F replaced it. Still manufactured for legacy support — if maintaining 1980s-2000s equipment, you will need these.
स्पेसिफिकेशन
|
Actuator Type
The button head style. Flush sits level with the bezel (prevents accidental presses). Extended protrudes for easy access.
|
Flush
|
|
Certifications
Third-party safety certifications. UL = required for US NEC installations. CE = EU compliance. CSA = Canadian standards.
|
UL, CSA
|
|
Color
Button/actuator color. Green = start/go, Red = stop/emergency, Yellow = caution, Blue = reset (per IEC 60204-1).
|
Red
|
|
Contact Configuration
Normally Closed — circuit is on until you press. Standard for stop/emergency functions. Wire in series with safety circuits.
|
1NC
|
|
Cutout Diameter
The hole size you drill in your panel to mount this button. 22mm is the most common industrial standard worldwide.
|
30.5mm
|
|
IP Rating
Ingress Protection rating — first digit is dust (0-6), second is water (0-9). Higher is better.
|
NEMA 4/13
|
|
Material
The bezel/body material. Metal bezels are more durable in harsh environments. Plastic is lighter and cheaper.
|
Metal
|
इंस्टॉलेशन त्वरित संदर्भ
Panel cutout: 30.5mm. Insert from the front of the panel, secure with mounting nut from behind (tighten to 2-3 Nm).
Contact block: Snap or screw the contact block onto the rear of the button body. Ensure the contact block orientation matches the wiring diagram — NO terminals are usually marked.
Wiring: Use 0.5-2.5mm² stranded wire with ferrules. Tighten screw terminals to 0.8 Nm. Test the button function before energizing the circuit.
आयाम
वायरिंग डायग्राम
समस्या निवारण
Button doesn't respond when pressed
Check the contact block first — it's the most common failure point. Test continuity across the NO or NC terminals with a multimeter. If no click is felt, the return spring in the head may be broken.
Works intermittently
Contact block contacts are pitted or burned. Replace the contact block — don't try to file the contacts. Check if the rated cycle count has been exceeded.
Button feels mushy or doesn't click
The spring return mechanism in the button head is worn. Replace the head. The contact block can usually be reused if it tests OK.
कहाँ से खरीदें
मूल्य सीमा
$3.49 — $63.62
3 वितरकों से
संक्षिप्त स्पेसिफिकेशन
- Actuator Type
- Flush
- Certifications
- UL, CSA
- Color
- Red
- Contact Configuration
- 1NC
- Cutout Diameter
- 30.5mm
उपयोगकर्ता क्या कह रहे हैं
“Legacy 30mm stop button found on older North American machinery. The 800T series was the standard before the 22mm 800F replaced it. Still manufactured for legacy support — if maint”