402401
ActivoPITgatebox E-Stop with Guard Locking
Pilz PITgatebox — safety gate box with integrated e-stop and guard locking.
Aplicaciones comunes
All-in-one safety station for machine guarding. Combines e-stop mushroom button, guard lock monitoring, and reset button in a single IP67 enclosure. Mounts at the machine gate entry point. Wire to Pilz PNOZ safety relay or PNOZmulti controller for SIL 3 / PLe rated safety circuits. Eliminates the need for separate e-stop, guard switch, and reset button.
Especificaciones
|
Actuator Function
Momentary = springs back when released. Maintained/latching = stays pressed until pressed again.
|
Twist-release
|
|
Actuator Type
The button head style. Flush sits level with the bezel (prevents accidental presses). Extended protrudes for easy access.
|
Mushroom 40mm
|
|
Certifications
Third-party safety certifications. UL = required for US NEC installations. CE = EU compliance. CSA = Canadian standards.
|
CE, UL, SIL 3, PLe, IEC 62061, ISO 13849
|
|
Color
Button/actuator color. Green = start/go, Red = stop/emergency, Yellow = caution, Blue = reset (per IEC 60204-1).
|
Red/Yellow/Green
|
|
Contact Configuration
Normally Open — circuit is off until you press. Standard for start/go/enable functions.
|
2NC + 1NO (e-stop) + guard lock monitor
|
|
IP Rating
IP67: Dust-tight and survives temporary water submersion (1m for 30 min). Handles oil splashes, steam cleaning, and rain.
|
IP67
|
Referencia rápida de instalación
Panel cutout: 22mm. Mount with the yellow backing plate visible (required by EN/ISO 13850).
Wiring: Wire NC contacts in series with the safety relay input channels. Use dual-channel wiring for SIL 3 / PLe applications. Never wire directly to a motor contactor.
Testing: Press the e-stop and verify the machine stops within the required time. Test the reset mechanism. Repeat monthly per EN/ISO 13850.
Dimensiones
Diagrama de cableado
Solución de problemas
E-stop won't reset (twist/pull doesn't release)
Check for debris in the mechanism. For twist-release: turn clockwise 45-90 degrees. For push-pull: pull straight out firmly. If the mechanism is stuck, the internal latch may be damaged — replace the entire head assembly.
Machine doesn't stop when e-stop is pressed
Critical safety issue. Immediately lock out the machine. Check wiring — NC contacts must be in series with the safety relay. Verify the safety relay is functioning. A broken wire in an NC circuit should cause a stop, so check for a wiring bypass.
Safety relay faults after e-stop reset
The safety relay detects a cross-fault between the two monitoring channels. Check that both NC contacts on the e-stop are switching simultaneously. One contact may be welded closed — replace the contact block.
Dónde comprar
Rango de precios
$1.19 — $15.68
en 2 distribuidores
Especificaciones rápidas
- Actuator Function
- Twist-release
- Actuator Type
- Mushroom 40mm
- Certifications
- CE, UL, SIL 3, PLe, IEC 62061, ISO 13849
- Color
- Red/Yellow/Green
- Contact Configuration
- 2NC + 1NO (e-stop) + guard lock monitor
Lo que dicen los usuarios
“All-in-one safety station for machine guarding. Combines e-stop mushroom button, guard lock monitoring, and reset button in a single IP67 enclosure. Mounts at the machine gate entry point. Wire to Pil”