MP1-10W
نشطABB MP1-10W Modular White Flush Pushbutton Head (head-only)
ABB white flush push button.
التطبيقات الشائعة
White for general/neutral functions on ABB panels. Completes the full ABB MP color range.
المواصفات
|
Actuator Type
The button head style. Flush sits level with the bezel (prevents accidental presses). Extended protrudes for easy access.
|
Flush
|
|
Certifications
Third-party safety certifications. UL = required for US NEC installations. CE = EU compliance. CSA = Canadian standards.
|
UL, CSA, CE
|
|
Color
Button/actuator color. Green = start/go, Red = stop/emergency, Yellow = caution, Blue = reset (per IEC 60204-1).
|
White
|
|
Contact Configuration
Normally Open — circuit is off until you press. Standard for start/go/enable functions.
|
None integral (head-only; add ABB MCB contact block + MCBH holder)
|
|
Cutout Diameter
The hole size you drill in your panel to mount this button. 22mm is the most common industrial standard worldwide.
|
22mm
|
|
Device type
|
ABB MP Modular pushbutton HEAD (non-illuminated, white flush)
|
|
Pn note
|
Corrected: ABB MP series is head-only (MCB contact block + MCBH holder separate). Stored 1NO misattributed. Same modular pattern as MP3 #357/#358.
|
|
Type designation
|
MP1-10W (1SFA611100R1005)
|
مرجع سريع للتركيب
Panel cutout: 22mm. Insert from the front of the panel, secure with mounting nut from behind (tighten to 2-3 Nm).
Contact block: Snap or screw the contact block onto the rear of the button body. Ensure the contact block orientation matches the wiring diagram — NO terminals are usually marked.
Wiring: Use 0.5-2.5mm² stranded wire with ferrules. Tighten screw terminals to 0.8 Nm. Test the button function before energizing the circuit.
الأبعاد
مخطط التوصيل
استكشاف الأعطال وإصلاحها
Button doesn't respond when pressed
Check the contact block first — it's the most common failure point. Test continuity across the NO or NC terminals with a multimeter. If no click is felt, the return spring in the head may be broken.
Works intermittently
Contact block contacts are pitted or burned. Replace the contact block — don't try to file the contacts. Check if the rated cycle count has been exceeded.
Button feels mushy or doesn't click
The spring return mechanism in the button head is worn. Replace the head. The contact block can usually be reused if it tests OK.
أين تشتري
نطاق السعر
$7.16 — $15.79
عبر 3 موزع
مواصفات سريعة
- Actuator Type
- Flush
- Certifications
- UL, CSA, CE
- Color
- White
- Contact Configuration
- None integral (head-only; add ABB MCB contact block + MCBH holder)
- Cutout Diameter
- 22mm
ما يقوله المستخدمون
“White for general/neutral functions on ABB panels. Completes the full ABB MP color range.”