Emergency Stop Switches / E-Stop Switches ESTOP,DPST,3A,1.5A AC / 220mA,110mA DC,Red
Research Notes
1. What this is
E100-R22-N10R is an E-Switch LED indicator.
2. Part-number decode
- Series: E-Switch LED indicator
- Type: LED indicator
3. Compatibility & ordering
E-Switch makes tactile, pushbutton (incl. anti-vandal/illuminated), toggle, slide, and appliance switches for electronics and industrial controls. Match by type, actuation (momentary/maintained), illumination, sealing, and mounting, then use the E-Switch datasheet to confirm the exact contact form and termination encoded in the part number.
4. Data-quality note
The E-Switch product line/type is identified; the detailed configuration is left to the datasheet rather than guessed. Flagged decoded-partial.
5. Sources
- E-Switch product catalog (e-switch.com)
- Distributor listing (DigiKey / Mouser) — search the exact part number
1 source
- E-Switch — E100-R22-N10R — e-switch.com
Specifications
|
Device class
|
LED indicator
|
|
Enriched by
|
eswitch-decoder-2026-08-12
|
|
Lead time
|
0 Days
|
|
Manufacturer series
|
LED indicator
|
|
Mouser part number
|
612-E100-R22-N10R
|
|
Pn status
|
decoded-partial
|
|
Rohs status
|
RoHS Compliant
|
|
Series description
|
E-Switch LED indicator / panel-mount LED (E-Switch also supplies discrete and panel LED indicators — L16/LL/GS/E-series)
|
Installation Quick Reference
Panel cutout: 22mm. Mount with the yellow backing plate visible (required by EN/ISO 13850).
Wiring: Wire NC contacts in series with the safety relay input channels. Use dual-channel wiring for SIL 3 / PLe applications. Never wire directly to a motor contactor.
Testing: Press the e-stop and verify the machine stops within the required time. Test the reset mechanism. Repeat monthly per EN/ISO 13850.
Dimensions
Troubleshooting
E-stop won't reset (twist/pull doesn't release)
Check for debris in the mechanism. For twist-release: turn clockwise 45-90 degrees. For push-pull: pull straight out firmly. If the mechanism is stuck, the internal latch may be damaged — replace the entire head assembly.
Machine doesn't stop when e-stop is pressed
Critical safety issue. Immediately lock out the machine. Check wiring — NC contacts must be in series with the safety relay. Verify the safety relay is functioning. A broken wire in an NC circuit should cause a stop, so check for a wiring bypass.
Safety relay faults after e-stop reset
The safety relay detects a cross-fault between the two monitoring channels. Check that both NC contacts on the e-stop are switching simultaneously. One contact may be welded closed — replace the contact block.
Where to Buy
Quick Specs
- Device class
- LED indicator
- Enriched by
- eswitch-decoder-2026-08-12
- Lead time
- 0 Days
- Manufacturer series
- LED indicator
- Mouser part number
- 612-E100-R22-N10R