9001BWRY

Active

Square D 9001BWRY

Square D 9001BWRY — Square D 9001BWRY

Emergency Stop Switches / E-Stop Switches CONTROL STATION COVER+BOX, BF+BW

Research Notes

1. What this is

9001BWRY is a Square D 9001 command device.

2. Part-number decode

  • Series: Square D 9001
  • Type: command switch
  • Panel cutout: 30.5mm

3. Compatibility & ordering

Square D (Schneider's US brand) makes the Class 9001 30mm heavy-duty command switches and Harmony devices. Match by type, actuation, illumination, sealing, and mounting, then use the manufacturer datasheet to confirm the exact contact and termination encoded in the part number.

4. Data-quality note

The Square D product line/type is identified; the detailed configuration is left to the datasheet rather than guessed. Flagged decoded-partial.

5. Sources

  • Square D product catalog (se.com)
  • Distributor listing (DigiKey / Mouser) — search the exact part number

1 source
  1. Square D — 9001BWRY — se.com

Specifications

Device class
command switch
Enriched by
squared-decoder-2026-08-12
Lead time
0 Days
Manufacturer series
9001
Mouser part number
996-9001BWRY
Panel cutout
30.5mm
Pn status
decoded-partial
Rohs status
Series description
Square D Class 9001 30mm command device / accessory

Installation Quick Reference

Panel cutout: 22mm. Mount with the yellow backing plate visible (required by EN/ISO 13850).

Wiring: Wire NC contacts in series with the safety relay input channels. Use dual-channel wiring for SIL 3 / PLe applications. Never wire directly to a motor contactor.

Testing: Press the e-stop and verify the machine stops within the required time. Test the reset mechanism. Repeat monthly per EN/ISO 13850.

Dimensions

Troubleshooting

E-stop won't reset (twist/pull doesn't release)

Check for debris in the mechanism. For twist-release: turn clockwise 45-90 degrees. For push-pull: pull straight out firmly. If the mechanism is stuck, the internal latch may be damaged — replace the entire head assembly.

Machine doesn't stop when e-stop is pressed

Critical safety issue. Immediately lock out the machine. Check wiring — NC contacts must be in series with the safety relay. Verify the safety relay is functioning. A broken wire in an NC circuit should cause a stop, so check for a wiring bypass.

Safety relay faults after e-stop reset

The safety relay detects a cross-fault between the two monitoring channels. Check that both NC contacts on the e-stop are switching simultaneously. One contact may be welded closed — replace the contact block.

Photos & Drawings

Images: mouser.com

Quick Specs

Device class
command switch
Enriched by
squared-decoder-2026-08-12
Lead time
0 Days
Manufacturer series
9001
Mouser part number
996-9001BWRY